Use and Care Manual

PARTS AND FEATURES
a
f
g
c
d
b
e
i
h
A
Control Panel
B
Dehumidied Dry
Air Vent
C
Handle
D
Water Collection
Bucket
E
Casters
F
Humid Air Intake
G
Air Filter
H
Direct Drain
Outlet
I
Drain Pump
Connector
INSTALLATION REQUIREMENTS
LOCATION REQUIREMENTS
•
Place the dehumidier on a at, level, surface to avoid
shaking, vibration and water spilling.
•
The surface must be strong enough to support the
dehumidier when the collection bucket is full of water.
•
Maintain a minimum 8" (20 cm) clearance around the
dehumidier to dissipate the heat properly.
20"
(51 cm)
20"
(51 cm)
20"
(51 cm)
20" (51 cm)
•
Keep the dehumidier free of any obstructions such as
drapes, curtains, blinds, etc.
•
Keep all windows and doors to the outside closed when
operating the dehumidier. Humid air will increase the
dehumidier’s workload.
•
Do not place the dehumidier in an area where the
temperature will fall below 38°F (3°C). Lower
temperatures may cause a layer of frost to accumulate
which will decrease performance.
•
Do not place the dehumidier in direct sunlight or near a
heat source such as baseboard heaters, stoves, etc.
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
3
ENGLISH