FDW2002 Domestic Dishwasher FDW2002 CONTENT Safety Is a Good Habit to Get Into Close-up View (control panel) Close-up View (Interrior) Salt Detergent and Rinse Aid ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Energy Saving Tips ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Safety Is a Good Habit to Get Into NOTICE Carefully read the instructions contained in - Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. this manual,as they provide important information which is essential to safe and proper - This appliance cannot be installed outdoors, not even if the area in which it is installed is installation, use and maintenance of the appliance.
Close-up View (control panel) A B C FDW2002 ON OFF S R F A B C E D D E F ON-OFF Light ON-OFF Button Low Salt Indicator Light KOK Knob For Selecting Cycle Handle For Opening Door "Eco" Button
Close-up View (Interrior) A B C D Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack E F G H Washing Filter Bottom Spray Arm Detergent and Rinse Aid Dispenser Salt Container Cap Technical characteristics Width 60cm Depth 60cm Height 85cm Capacity 12 standard place settings Mains water pressure 0.03-0.
S a l t Salt Adjusting Salt Consumption The hardness of the water varies from place to The dishwasher is equipped with a system to adjust the level of salt consumption in function place. If hard water is used in the dishwasher, desposits will form on the dishes and utensils.
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must be used.The dispenser This product makes dishes sparkle and helps them to dry without spotting.The dispenser is must be refilled before the start of each wash cycle following the instructions provided in the located on the inside panel of the door and should be filled after every 80 wash cycle. "Wash Cycle Table."The detergent dispenser is located on the inside panel of the door.
Loading the Dishwasher Lower Rack Before placing the dishes in the dishwasher, remove Upper Rack the large food particle to prevent the filter from becoming clogged,which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed.This will eliminate the need for extra wash cycles. Pull out the racks to facilitate loading the dishwasher.
Starting the Appliance Starting a wash cycle At the end of the wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. When the knob stops turning and is aligned with a STOP mark(see figure),the cycle has - Make sure that the water supply is turned on to full pressure. finished.Turn off the appliance using the ONOFF button,turn off the water supply and open - Load the dishwasher (see the section entitled, "Loading the Dishwasher"). the door of the dishwasher.
Wash Cycle adjustment Buttons ======_ìííçå This button(see "close-up View - Control Panel",letter" F")is used for normally dirty dishes, pots and pans.It is standard daily cycle. Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded to save on energy.In order to prevent odours from forming and food from caking onto the dishes,you can run the hold cycle.
Wash Cycle Table Cycle Cycle Selection Information Desciption of Cycle Button Very dirty dishes,pots and pans(not to be used with delicate items). Heavy Duty Very dirty dishes,pots and pans(not to be used with delicate items). Heavy Duty Pre-wash with hot water. Extended wash at 65 K Rinse with cold water. Rinse with hot waterK Drying. Pre-wash with hot water. Extended wash at 55 K Rinse with cold water. Rinse with hot water. Detergent Rinse Aid 30g 30g 30g Drying.
How to Keep Your Dishwasher in Shape After Every Wash When You Go on Holiday After every wash, turn off the water supply to When You Go on Holiday,it is recommended that you run a wash cycle with the dishwasher the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. empty and then remove the plug from the socket ,turn off the water supply and leave the Remove the Plug door of the appliance slightly ajar.
Cleaning and Special Maintenance Filter Assembly Cleaning the Sprayer Arms For best performance and results, the filter assembly must be cleaned. It may happen that food particle become encrusted on the sprayer arms and block the The filter efficiently removes food particles from the wash water,allowing it to be recircu- hole. Check the sprayer arms periodically and clean them when needed. (see "Close up view lated during the cycle.
Troubleshooting It may occur that the dishwasher does not function or does not function properly.Before The Dishwasher Does Not Drain calling for assistance,Iet us see what can be done first:have you forgot to press one of the - the drain hose is crimped or bent.
Installation Positioning the Appliance Hot Water Connection Positioning the appliance in the desired The water supply to the appliance can also be connected to the house's hot water line location.The back should rest against the wall behind it,and the sides,along the adjacent cabinets or wall.The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.
Installation Drain Hose Connection Electrical Connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the After making sure that the voltage and frequency values for the current in the home cor- sink,making sure to avoid bending or crimping it.Use the special plastic support that respond to those on the rating plate(located on the stainless steel inner door of the comes with the appliance (see fig .C).
Installation Diagram
