Domestic Dishwasher WQP12-AFM2 GB `çÇÉW=MNOMRMQMPO^
Safety Is a Good Habit to Get Into NOTICE * If the appliance is not operating properly or maintenance must Carefully read the instructions contained in this manual,as they provide important information which is essential to safe and proper be performed,disconnect the appliance from the power supply. - Keep detergents out of the reach of children,who must also be installation, use and maintenance of the appliance. kept away from the dishwasher when it is open.
Close-up View (Interior) A B C D Upper Rack E F G H Rack Height Adjustor Top Spray Arm Lower Rack Bottom Spray Arm Washing Filter Detergent and Rinse Aid Dispenser Salt Container Cap Technical characteristics Width 60 cm Depth 60 cm Height 85 cm Capacity 12 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~ 50Hz Total absorber power GB 2100W .2.
S a l t Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard The dishwasher is equipped with a system to adjust the level of water is used in the dishwasher,deposits will form on the dishes utensils. salt consumption in function of the hardness of the water being used in order to optimize and customize the level of salt con- The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used.The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle out spotting.The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycles. Table ".The detergent dispenser is located on the inside panel the door.
Loading the Dishwasher Before placing the dishes in the dishwasher, remove the large food Lower Rack particle to prevent the filter from becoming clogged,which results in reduced performance. Upper Rack If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed.This will eliminate the need for extra wash cycle. Pull out the rack to facilitate loading the dishwasher.
Starting the Appliance Starting a wash cycle At the end of the wash cycle - Make sure that the plug for the appliance is inserted into the wall When the knob stops turning and is aligned with a STOP mark socket. - Make sure that the water supply is turned on to full pressure. (see figure),the cycle has finished.Turn off the appliance using the ON-OFF button,turn off the water supply and open the door - Load the dishwasher (see the section entitled,"Loading the Dishwasher"). of the dishwasher.
Wash Cycle Table Cycle Button Cycle Selection Information Description of Cycle Detergent Rinse Aid 30 g 30 g 30 g Pre-wash with hot water. Very dirty dishes,pots and pans . Extended wash at 65 (not to be used with delicate items). Rinse with cold water. Rinse with hot water. Heavy Duty Drying. Pre-wash with hot water. Heavy Duty Very dirty dishes,pots and pans . Extended wash at 55 (not to be used with delicate items). Rinse with cold water. Rinse with hot water. Drying.
Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded to save on enery.In order to prevent odours from form ing and food from caking onto the dishes,you can run the soak cycle. - Choose the right wash cycle: the choice of cycle depends on - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes,but,rather,a greater nega tive impact on the enviroment.
Cleaning and Special Maintenance Filter Assembly Cleaning the Spray Arms For best performance and results, the filter assembly must be It may happen that food particle become encrusted on the sprayer cleaned. The filter efficiently removes food particles from the wash water, arms and block the hole. Check the sprayer arms periodically and clean them when needed. (see "Close up view [interior]", allowing it to be recirculated during the cycle.
Installation Positioning the Appliance Drain Hose Connection Position the appliance in the desired location.The back should rest against the wall behind it,and the sides,along the adjacent Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the sink,making sure to avoid bending or cabinets or wall.The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to crimping it.
Installation Diagram
