Domestic Dishwasher ED60SS ED60WH GB Code: 0120503871
Safety Is Very Important - If the appliance malfunctions turn off water supply to the appliance and disconnect the plug from the wall socket. Refer to the section entitled, "Troubleshooting". If you cannot solve the problem, contact a authorised service centre. - Only specialised personnel are authorised to make repairs. - Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock.
Close-up View (Interior) A B C D E F G H Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack Bottom Spray Arm Washing Filter Detergent and Rinse Aid Dispenser Third Sprayer Technical Characteristics Width 60 cm Depth 60 cm Height 85 cm 12 standard place settings Capacity Mains water pressure 0.03-0.6MPa Power voltage 240V~ 50Hz Total absorber power GB 2200W .2.
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle out spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycle (or when the Table." The detergent dispenser is located on the inside panel the door.
Loading the Dishwasher Before placing the dishes in the dishwasher, remove any large food particles to prevent the filter from becoming clogged. A clogged filter will result in reducing performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycles. Lower Rack Upper Rack Pull out the rack when loading the dishwasher.
Turning on the Appliance Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the susceptible to breakage. They will also dry better. Dishwasher" on page 4).
Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded to save on energy. In order to prevent odors from form- - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater negative impact on the environment. ing and food from caking onto the dishes, you can run the PreRinse cycle.
Wash Cycle Table Cycle Eco Fast Button Button Cycle Selection Information Description of Cycle Deter- Rinse gent Aid Pre-wash with cold water. Heavy Very dirty dishes, pots and Rinse with cold water. pans (not to be used with Extended wash at 60 K delicate items). Rinse with hot waterK 30g 30g 25g 25g Drying. Pre-wash with cold water. Very dirty dishes, pots and Heavy pans. (not to be used with Rinse with cold waterK Extended wash at 50 K Rinse with hot waterK Drying.
Cleaning and Special Maintenance Filter Assembly Cleaning the Spray Arms For best performance and results, the filter assembly must be It may happen that food particles become encrusted on the sprayer cleaned. The filter efficiently removes food particles from the wash water, arms and block the hole (see "Close up view [interior]" on page 1, letters C-E ). Check the sprayer arms periodically and clean them allowing it to be recirculated during the cycle.
Installation Positioning the Appliance The connection must be made to the hot water line following the Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent same procedures as those for the connection to the cold water line. cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to Anti-Flooding Protection ensure correct installation.
Installation GB .10.