Use and Care Manual

49-60810-1

IMPORTANT: Handle with care when moving dual-drawer refrigerator to

avoid either damaging the refrigerant tubing or increasing the risk of a leak.

IMPORTANT: When moving the dual-drawer refrigerator, never tilt it more

than a 45° angle. This could damage the compressor and the sealed system.

If the dual-drawer refrigerator has been placed in a horizontal position for

any period of time, wait 30 minutes before plugging in the refrigerator to

allow the refrigerant to settle.

REMOVE PACKAGING

¿ Remove tape and glue residue from surfaces before turning on the

dual-drawer refrigerator. Rub a small amount of liquid dish soap over the

adhesive with your fingers. Wipe with warm water and dry.

NOTE: Do not use sharp instruments, rubbing alcohol, flammable fluids,

or abrasive cleaners to remove tape or glue. These products can damage

the surface of your dual-drawer refrigerator. For more information, see

“Dual-Drawer Refrigerator Safety.”

¿ Dispose of/recycle all packaging materials.

CLEAN BEFORE USING

After you remove all of the packaging materials, clean the inside of the dual-

drawer refrigerator before using it. See the cleaning instructions in “Dual-

Drawer Refrigerator Care.”

ENGLISH

INSTALLATION INSTRUCTIONS

STEP 1 - UNPACK DUAL-DRAWER REFRIGERATOR

WARNING

EXCESS WEIGHT HAZARD

Use two or more people to move and install dual-drawer refrigerator.

Failure to do so can result in back or other injury.

WARNING

CUT HAZARD

Cabinet edges along stamp/cut-out areas may be sharp. Avoid placing

hands, fingers or other appendages near these areas.

Failure to do so can result in cuts.