Built-in installation(without worktop) remove the worktop Built-in installation
Installation instructions ing transport, any water left inside may enclose parts and in accordance with the inseep into the control module and cause stallation instruction subsequcent error with programme Water pressure: function. Minimum 3x104-maximum 106Pa. The appliance must be drained in the folIf the water pressure is higher,install a lowing sequence: pressure reducing valve. - Set main switch to ON Rinse simultaneously. - Wait a further minute and then hoses at same time.
Other information White stains are left on crockery, Tea stains or traces of lipstick glasses have a milky appearance have not been completely removed. - Detergent does not have a sufficient - Not enough detergent was added to input compartment. - Amount of rinse-aid was set too low. bleaching effect. - Washing temperature was set too low. Traces of rust on cutlery - If you used a phosphate-free detergent, try a detergent containing phosphates and compare results. - Cutlery is not sufficiently rustproof.
Fault finding Resolving minor problems yourself With the appliance itself Error display F on the numercial display Experience has shown that you can resolve - Tap not turned on. most problems that arise during normal daily - For appliance with Aquastop: usage yourself, without having to call out a Brief excess pressure in the water service engineer. Not only does this save mains; costs, but it also means that the appliance is The Aquastop system must be vented: available for use again that much sooner.
Care and maintenance Interruping the programme Drying - Set Start/Pause 9 to PAUSE. - Indicator lights extinguish. The When a programme without drying programme is retained in the dishwasher memory. - If or the appliance has already heated up and then the appliance door ajar for several minutes and then close.
Programme overview Condition of dishes Wash Programme Washing dishes Programme selection Normal Standard wash Dirty To be rinsed Intense wash Rinse The most appropriate programme can be - Set main switch 1to ON. identified by comparing the type of crockery, Indicators light up according to thelast cutlery,etc.,as well as the amount and con- programme that was selected. dition of food remains,with the details con- Indicators light up according to the last tained in the programme overview.
Detergents Lower rack - The lower rack is suitable for bowls,soup Information about detergents plate,frying pan,pan cover and plate,knife, You can use any brand or liquid or powder fork,spool and soup ladle,etc. detergent,as well as tables,that have been - Plates shoud be sent in one direction and specifically designed for use in domestic the bowls and cups should be set in the rack.Arrange the dishes for the best washing effect. - The detachable chopstick container is dishwashers.
Not suitable for the diashwasher Filling the rinse-aid container The purpose of a rinse-aid is to prevent the formation of water marks on tableware and What you should not put into the dishwasher: utensils, and to ensure that glasses are clean and sparking. The rinse-aid is consumed Cutlery and tableware manufactured in whole or part from wood. They become during the washing process. faded and unsightly in appearance. - The rinse liquid contaiter is right to the detergent contaiter.
Getting to know your dishwasher Safety information If a fault occurs At time of delivery - Check packaging and dishwasher immediately for signs of transport damaged. If the appliance is damaged, do not put into use but contact your supplier without delay. - Please dispose of packaging materials properly. During installation - Site the dishwasher and connect it up in accordance with the installation instructions.
WQP6-2A ON OFF 1 Power Indicator Delay timer 2 3 4 5 Start Standard Intense Rinse Pause Drying Drying Drying 7 8 6 Start Haier Domestic Dishwasher Pause 9 Index Safety information 11 Getting to know your dishwasher Filling the Rinse-aid container 12 Not suitable for the diashwasher Arranging crockery, 13 glasses,etc.
