Code: 0120505076
Safety Is Very Important - Keep detergents out of the reach of children. Also keep children away from the dishwasher when it is open to reduce the risk of injury. - This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof. It is also very dangerous to leave it exposed to the rain and elements. - Do not touch the heating element during or after a wash cycle. - Do not lean or sit on the door when it is open, as this could overturn the dishwasher.
Close-up View (Interior) A B C D E F G H Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack Bottom Spray Arm Washing Filter Detergent and Rinse Aid Dispenser Third Sprayer Technical Characteristics Width 60 cm Depth 60 cm Height 85 cm 12 standard place settings Capacity Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~ 50Hz Total absorber power GB 2200W .2.
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle out spotting. The dispenser is located on the inside panel of the door and should be filled after every 80 wash cycle (or when the Table." The detergent dispenser is located on the inside panel the door.
Loading the Dishwasher Before placing the dishes in the dishwasher, remove the large food particle to prevent the filter from becoming clogged, which results in reduced performance. Lower Rack Upper Rack If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycle. Pull out the rack to facilitate loading the dishwasher.
Turning on the Appliance Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the Dishwasher" on page 4).
Energy Saving Tips - It is important to try and run the dishwasher when it is fully loaded to save on energy. In order to prevent odors from form- - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater negative impact on the environment. ing and food from caking onto the dishes, you can run the prerinse cycle.
Wash Cycle Table Cycle Eco Button Fast Button Cycle Selection Information Description of Cycle Detergent Rinse Aid Duration in minutes Pre-wash with cold water. HEAVY Very dirty dishes, pots and Rinse with cold water. pans (not to be used with Extended wash at 60 K 30g about 151 30g about about Rinse with hot waterK delicate items). Drying. HEAVY Pre-wash with cold water. Very dirty dishes, pots and Rinse with cold waterK pans.
Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semi-circular filter and cup under running water. To remove the filter assembly, pull on the cup handle in an upward direction.
Installation Positioning the Appliance Hot Water Connection Position the appliance in the desired location. The back should The water supply to the appliance can also be connected to the rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60 .
Installation GB .10.
