Installation Guide

Without a breaker for current leakage will cause risks
of electric shock, fire or explosion.
Install a explosion-proof breaker for current leakage at the
power source to avoid the risk of the electric shock.
Do not use large-capacity fuses,steel wire,or copper wire.
Damaging the unit ,fire,smoke or explosion will be
caused otherwise.
16
Safety Precautions
Before Installing (Relocating) the Unit or Performing Electric Work
~ Caution
Ground the unit.
• Do not connect the grounding
on the unit to gas pipes,water
pipes, lightning rods, or the grounding terminals of
telephones. Improper grounding presents a risk
of electric
shock, smoke, fire,
or the noise caused by improper
grounding may cause the unit to malfunction.
Make sure the wires are not subject to tension.
• If the wires are too taut, they may break or generate heat
and/or smoke and cause fire.
•
•
Before the Test Run
Do not spray water on the air conditioners or immerse the
air conditioners
in water.
• Water on the unit presents a risk
of electric shock.
Periodically check the platform on which
is placed for damage
to prevent the unit from falling.
• If the unit
is left on a damaged plarform, it may topple over,
causing injury.
When installing draining pipes, follow the instructions
in the
manual, and make sure that they properly drain water so as
to avoid dew condensation.
• If not installed properly, they may cause water leaks and
damage the furnishings.
Properly dispose
of the packing materials .
• Things such as nails may be included
in the package.
Dispose
of them properly to prevent injury.
• Plastic bags present a choking hazard to children. Tear
up the plastic bags before disposing of them to prevent
accidents.
~ Caution
Do not operate switches with wet hands to avoid electric.
Do not touch the refrigerant pipes with bare hands during
and immediately after operation.
• Depending on the state
of the refrigerant in the system,
certain parts
of the unit such as the pipes and compressor
may become very cold or hot and may subject the person
to frost bites
or burning.
Do not operated the unit without panels and safety guards
in their proper places.
• They are there to keep the users from injury from
accidentally touching rotating, high-tempreture or high-
voltage parts.
Do not turn off the power immediately after stopping the unit.
• Allow for at least five minutes before turning off the unit,
otherwise the unit may leak water or experience other
problems.
Do not operate the unit without air filters.
• Dust particles
in the air may clog the system and cause
malfunction.