Installation Guide

20 30
15 2.5
201
30
2.5
25
25
20
1
ceramic type of AC 250V, T25A.
The explosion-proof breaker of the air conditioner should be all-pole switch. The distance between its two contacts should not be no
A explosion-proof breaker must be installed.
24
1U53WADFRA
09K
12K
18K
Model
Connecting wiring
Power cable
3G1.5mm²
1U26MADFRA
1U35MADFRA
-mod:18-24:3G2.5mm²
local
4G1.5mm²
4G1.5mm²
3G1.5mm²
3G2.5mm²
1U71WADFRA
Power cable:
-mod 09-12:
3G1.5mm
2
4G1.5mm
2
POWER
1U09MADFRA
1U12MADFRA
1U26MADFRA
1U35MADFRA
1U18WADFRA
1U24WADFRA
1U53WADFRA
1U71WADFRA
4G1.5mm²
24K
4G1.5mm²
3G2.5mm²
30
2.5
25
25
20
1
Power cable:
4G1.5mm
2
POWER
Installation Procedure
Electrical Wiring
WARNING!
DANGER OF BODILY INJURY OR DEATH
• TURN OFF ELECTRIC POWER AT CIRCUIT BREAKER OR POWER SOURCE BEFORE MAKING ANY ELECTRIC
CONNECTIONS.
• GROUND CONNECTIONS MUST BE COMPLETED BEFORE MAKING LINE VOLTAGE CONNECTIONS.
Precautions for Electrical wiring
• Electrical wiring work should be conducted only by authorized personnel.
•
Do not connect more than three wires to the terminal block. Always use round type crimped terminal lugs with insulated
grip
on the ends of the wires.
• Use copper conductor only.
Selection of size of power supply and interconnecting wires
Select wire sizes and circuit protection from table below. (This table shows 20 m length wires with less than 2% voltage
drop.)
I~
Circuit breaker
Power source
Earth leakage breaker
Phase
Switch breaker Overcurrent protector
wire size
Switch Leak
(minimum)
I
(A) rated capacity (A)
(mm
2
)
breaker(A) current(mA)
• If the supply cord
is damaged, it must be replaced by the manufacturer or itsservice agent or a similar qualified person.
• If the fuse
of control box is broken, please change it with the
• The wiring method should
be in line with the local wiring standard.
• All the cables shall have got the authentication certificate. During installation, when the connecting cables
break off, it must
be assured that the grouding wire is the last one to be broken off .
•
less than 3mm. Such means for disconnection must be incorporation in the fixed wiring.
• The distance between its two terminal blocks
of indoor unit and outdoor unit should not be over 5m. If exceeded, the
diameter
of the wire should be enlarged according to the local wiring standard .
•
Wiring procedure
1) Remove set screws on the side before taking off the front panel toward the direction.
2) Connect wires to the terminal block correctly and fix the wires with a wire clamp equipped nearby the terminal block.
3) Route the wires
in a proper way and penetrate the wires through the opening for electrical wiring on the side panel.
WARNING:
INTERCONNECTING WIRES MUST BE WIRED ACCORDING TO FIGURE BELOW INCORRECT WIRING MAY CAUSE
EQUIPMENT DAMAGE.