Installation Guide
NO
Wind direction
Air outlet
Cushion rubber
4.Installation dimension(Unit:mm)
20
Floor fixing dimensions
of the outdoor unit
(Unit:mm)
130
510
160
313
630
130 130
374
1U18WADFRA
1U09MADFRA
1U26MADFRA
1U12MADFRA
1U35MADFRA
1U53WADFRA
600
100
100
300
1U24WADFRA
1U71WADFRA
B=
Ø
60mm
B=
Ø
60mm
AS26PBDHRA
AS35PBDHRA
A=170mm C=130mm
43.4mm
43.4mm
B=
Ø
60mm
B=
Ø
60mm
AS53PDDHRA
AS71PDDHRA
A=222mm C=165mm
36mm
42mm
Installation Procedure
Installation
of
Outdoor Unit
1.
Accessories
"Edging" for protection
of
electrical wires from
an
opening edge.
2.
Selection
of
the place
of
installation
Select the place
of
installation satisfying the following conditions and, at the same time, obtain a consent from the client or
user.
• Place where air circulates.
• Place free from heat radiation from other heat sources.
• Place where drain water may be discharged.
• Place where noise and hot air may not disturb the neighborhood.
• Place where there is not heavy snowfall
in
the winter time.
• Place where obstacles do not exist near the air inlet and air outlet .
• Place where the air outlet may not be exposed to a strong wind.
• Place surrounded at four sides are not suitable for installation. A 1 m or more
of
overhead space is needed for the unit.
• Avoid mounting guide-louvers to the place where short-circuit is a possibility.
• When installing several units, secure sufficient suction space to avoid short circuiting.
Open space requirement around the unit
V Air inlet
;;,,
;;,,
;;,,
u
c::J;61
Q
Q)
(Servicing
E
space)
....
vAiroutlet
<(
;;,,
3.
Installation
of
outdoor unit
Note:
(1) Fix the parts with screws.
(2) Don't intake the strong wind directly to , t<:\
the outlet air-flow hole.
\.Y
(3) A one meter distance should be
kept from the unit top.
(4) Don't block the surroundings
of
the unit with sundries.
(5) If the outdoor unit is installed
in
a place that is exposed
to the wind, install the unit so that the outlet grid is NOT
pointing
in
the direction
of
the wind.
Fix the unit on the foundation
in
a proper way according to the
condition
of
the installation place, referring to the following
information.
• Give enough room for the concrete foundation to fix by anchor bolts.
• Place the concrete foundation deep enough.
• Install the unit so that the angle
of
inclination must be less than 3 degrees.
• Forbidden to place the unit
on
the ground directly.Please confirm there is enough room
near the drainage hole
on
bottom plate, which will ensure the water be drained smoothly.
~I
r---,,,,---;
------...---1--~
I
1
of
the outdoor unit
(Unil:mm)