Multi-Zone Technical Overview

PAGE 58 TECHNICAL OVERVIEW
ENGLISH
Slim Duct
Slim Duct Unit Technical Overview
The Slim Duct Indoor Unit will act as evaporator coils during
cooling mode and condenser coils during heating mode.
This unit can operate with a motorized supply air louver or
it can have a LIMITED amount of ducting added to the unit’s
return and supply air duct connection anges. The return air
ducting can be connected to the end of the cabinet or the
bottom blank o plate can be removed for bottom return
conguration.
DIP Switches on the unit’s circuit board congure the fan
power to match the ducting conguration.
The Slim Duct cabinet is insulated so that it can be installed
in unconditioned air. The unit is well suited for mounting in
sots, attics, and garages.
These units have a built in condensate pump with an
associated condensate level switch. The condensate pump
is capable of lifting water out of the indoor unit. If high water
lift is needed, the water from the cassette pump should be
pumped into a eld supplied condensate pump with high lift
power.
Slim Duct units are controlled by a wired
controller only.
Duct work Installation
Use rivet to connect the air
return duct on the air return inlet
of the indoor unit, then connect
the other end with the air return
Indoor unit
Soft
connection
or static
box
Transition
duct
Rounded
duct
Tie-in of air
distribution
Air distribution
Air return blind Air return duct
Indoor unit
Rivet
gluey nail
heat
preservation cotton
tinfoil
gluey nail cap
adhesive tape
Roof Installation
Ceiling
Air supply
Unit
Return air
Return air box
Roof
Air outlet grill
Air supply
Unit
Return air box
Return air
Long Duct
Suspending hook
Drain pipe
Air return duct
Air return blind
Air out duct
Transition duct
Tie-in of air
Distribution
Air distribution
Basic Duct Congurations
Here are the typical duct congurations that can be used with
the unit.
1
2
3
4
5
6
7
Return Air
Temperature Sensor
Pipe Sensor
Evaporator Coil
Control Board
Blower Motor
Terminal Block
Condensate Pump
Gravity Drain Ports
8
Control Board
Blower
Motor
Return Air
Temperature
Sensor
Pipe
Sen sor
Evaporator
Coil
Terminal Block
Condensate Pump
Gravity
Drain Ports
8
1
2
3
4
5
6
7