User's Manual

18
more. If the computer still does not respond, remove the AC power adapter.
•Your computer might lock when it enters sleep mode during a communication
operation. Disable the sleep timer when you are working on the network.
The connected external device does not work
•Do not connect or disconnect the non-USB cable device in the boot state, otherwise
you may damage your computer.
•When using high power consumption external devices such as an external USB
optical disk drive, use an external device power adapter. Otherwise, the device may
not be recognized, or the system may shut down as a result.
FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications
not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device was evaluated for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 25 mm must be maintained
between the user’s body or the handset, including the antenna. The highest
Calculated Threshold Value is 2.21, which is less the SAR Test Exclusion Threshold
limit for 1-g SAR to determine SAR test exclusion.