User Manual

HI-601VT Decoder

How to Use:

A.Connect the inclusive phone jack/PSII to mini1394 Y cable

to the decoder: Mini1394 connector to the side of the

decoder, phone jack to the phone jack outlet)

B.As soon as turn on the power switch, the red LED light start

blinking once per second. The updated coordinates will be

sent out from “mini-1394 output” and “Bluetooth output”

each second.

PS. The data format is 4800, 8, N, 1 and computer will take the

RS232 data from COM 1, COM2 or other com port.

C.Start mapping software and activate the GPS signal

receiving. The most update location (or the last location) will

be shown on the mapping software.

D.The orange LED light (GPS in 3D fixed) followed by the red

light meaning the data is valid and is the real time location

coordinate. The status also means that the car or the person

should be in outdoor and the GPS receiver able to gets and

lock more than 4 satellites. If the yellow light not lighted

meaning the GPS data is not the real time coordinate (could

be the old location coordinate) The status also means that

the car or the person should be indoor and the GPS receiver

unable to gets and lock more than 4 satellites.