Tus neeg siv phau ntawv

[How to assemble – Use M3 spanner]
1) Fix the Rod-end with the included M3 spanner (⑤).
This is to prevent the rod (①) from turning badly and damage while tightening the M3 nut (②).
2) According to preference, install the socket set screw (③) or rod end tip (④) to the proper positioning before hard
tightening.
3) Adjust the angle of the rod end tip (④) to the desired angle. By using included M3 spanner(⑦), adjust the position by
tightening the M3 nut (②) while rod end is FIXED with another M3 spanner(see below image.).
This is “double nuts” concept which fixes mechanical position by friction.
Caution : The rod-end tip (④) or Socket set screw (③), which are basic accessories, can be fastened through the M3 standard
tapping hole of the rod-end (6), and other customized rod-end tip can be installed according to the customer’s desire.
However, when fastening the object to the rod-end, make sure to fix the rod-end (⑥) with an M3 spanner. If you excessively
apply the force to the rod (①) without fixing the rod-end (⑥) with an M3 spanner, it may cause damage to the internal parts.
6. Lateral rod shaking when operating
When no-load operation of some actuator, there may be a slight lateral shaking of the rod (Chattering). This phenomenon
may occur depending on the assembly tolerance of the product, but it does not matter at all as this phenomenon disappears
when certain load is applied. Please use actuator with confidence.
7. Sound during operation
Due to the nature of the product mechanism, our actuators generate a mechanical sound during operation. (Specification
standard: 50db or less at 1m distance)
8. Speed difference at no load
There may be a slight difference in speed of the same model at no load condition, but the difference drastically decreases
when certain load is applied. However, please use the actuators with the understanding that the speed of same model
cannot be completely same at no load condition. For your reference, in the case of the force control line-up, you can use
the speed parameter to synchronize the speed of multiple products.
9. Tolerance of start point/end point
Please be advised that the start point and end point position of the rod allow a tolerance of up to +/-0.5mm. If you need to
make the start point of all the actuators same, please contact us before purchase so that we can do some custom-tuning
for you. (Some customizing costs incurred)
10. Do not disassemble
The mightyZAP is built with a lot of small precision parts inside, so we are not able to guarantee its quality if the product is
disassembled/assembled again by unskilled person. To prevent any disassembly/reassembly at user’s discretion, we attached
sticker on the case. If the sticker is damaged, please understand that the warranty may be void. If you need repair or inspection,
please contact [e-mail] for further process.
FIX!