SDS

6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures
Personal precautions Avoid contact with skin, eyes or clothing. Ensure adequate ventilation. Use personal
protective equipment as required. Evacuate personnel to safe areas.
Other Information Refer to protective measures listed in Sections 7 and 8.
Environmental precautions Prevent further leakage or spillage if safe to do so.
Methods and material for containment and cleaning up
Methods for containment Prevent further leakage or spillage if safe to do so.
Methods for cleaning up Pick up and transfer to properly labeled containers.
Prevention of secondary hazards Clean contaminated objects and areas thoroughly observing environmental regulations.
7. HANDLING AND STORAGE
Precautions for safe handling
Advice on safe handling In case of rupture: Handle in accordance with good industrial hygiene and safety practice.
Avoid contact with skin, eyes or clothing. Ensure adequate ventilation. Do not eat, drink or
smoke when using this product. Take off contaminated clothing and wash before reuse.
Conditions for safe storage, including any incompatibilities
Storage Conditions Keep containers tightly closed in a dry, cool and well-ventilated place. Protect from
moisture. Store locked up. Keep out of the reach of children. Store away from other
materials.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Control parameters
Exposure Limits The following ingredients are the only ingredients of the product above the cut-off level (or
level that contributes to the hazard classification of the mixture) which have an exposure
limit applicable in the region for which this safety data sheet is intended or other
recommended limit. At this time, the other relevant constituents have no known exposure
limits from the sources listed here.
Chemical name
ACGIH TLV
OSHA PEL
NIOSH IDLH
Copper
7440-50-8
TWA: 0.2 mg/m3 fume
TWA: 0.1 mg/m3 fume
TWA: 1 mg/m3 dust and mist
(vacated) TWA: 0.1 mg/m3 Cu
dust, fume, mist
IDLH: 100 mg/m3 dust, fume
and mist
TWA: 1 mg/m3 dust and mist
TWA: 0.1 mg/m3 fume
Aluminum
7429-90-5
TWA: 1 mg/m3 respirable
particulate matter
TWA: 15 mg/m3 total dust
TWA: 5 mg/m3 respirable fraction (vacated)
TWA: 15 mg/m3 total dust(vacated)
TWA: 5 mg/m3
respirable fraction
TWA: 10 mg/m3 total dust
TWA: 5 mg/m3
respirable dust
Phosphate(1-), hexafluoro-,
lithium
21324-40-3
TWA: 2.5 mg/m3 F
TWA: 2.5 mg/m3 F
(vacated) TWA: 2.5 mg/m3
IDLH: 250 mg/m3 F