Installation Instructions

ManualsBrandsHahn ManualsHome ImprovementCopper Large Undermount Single Bowl Kitchen Sink

General Recommendations:

Please read installation and care instructions thoroughly. Inspect your sink for

any noticeable damage before installation. Check all local applicable plumbing

and building codes.

These instructions are based on application to composite material or solid

surface countertop installation only; countertop application to stone, marble,

granite or butcher-block should be referred to an experienced countertop

fabricator for custom installation.

We suggest using experienced and professional installers only. For custom

cutting of countertop and installation of the actual sink, on-site installation is

also recommended. Acceptable variances are approximately 1/8 of an inch.

Alignment to the cut-out and precise application and trimming of any adhesive

sealant are critical to a superior t and nished look.

Hahn sinks does not accept any liability for damage to countertop, sink xture,

faucets or personal injury during installation. Warranty is void if installation

instructions are not followed.

Installation Instructions:

1. Unpack and check the contents supplied: Sink,

Mounting Brackets and Cutout Template

2. The Cutout Template provides 3 options for installation

(see reverse for Countertop Reveal Options). Trace

the outline of the template and cut countertop along

the inside of the line using appropriate cutting tools.

Template is for guide only — Use the physical sink to

ensure accurate cutout opening.

3. Locate and drill holes on the underside of the coun-

tertop, approximately 1” from edge of the sink to be

installed. Holes should be evenly spaced approxi-

mately 6” to 8” apart starting from every corner. It is

recommended to install a faucet at this point before

installing the sink.

4. Loosely attach mounting brackets to the countertop,

parallel to the cutout opening using the mounting

screws and buttery nuts.

5. Clean sink ange and underside of cutout area of

countertop, making sure that the area is smooth and

free from grease. Apply continuous bead of silicone

caulk evenly on top of sink ange.

6. Position and align sink over countertop opening and

press sink onto countertop. Turn bent end of mounting

bracket to snug over the sink rim. Check alignment of

sink again and tighten fasteners to secure sink.

8. Wipe away excess silicone caulk with a damp cloth.

Connect drain and water supply according to manu-

facturer’s instructions.

Applicable Sink Models:

Copper Series

CO002, CO004

Tools / Materials Needed:

• Tape Measure

• Hacksaw / Jigsaw

• Rags

• Pencil (Not Ink)

• Ear and Eye Protection

• Denatured Alcohol

• Silicone Adhesive Sealant

• Mounting Clips

Be sure to use proper tools and always

wear personal safety devices for your

protection.

Installation and Care Manual

Non-Farmhouse Style Sinks

CAUTION: Undermount sinks require that your countertop is fabricated to

exacting standards and the sink be installed using meticulous procedures.

We recommend that you leave the installation to a seasoned professional.

Summary of content (2 pages)

PAGE 1
Installation and Care Manual Non-Farmhouse Style Sinks General Recommendations: Applicable Sink Models: Please read installation and care instructions thoroughly. Inspect your sink for any noticeable damage before installation. Check all local applicable plumbing and building codes.
PAGE 2
! CAUTION: All installation types need to allow room for faucet installation. Ensure adequate clearance behind the sink for any faucet and backsplash, as well as full range of motion for faucet spouts and handles. Countertop Reveal Options: + 0 Positive Reveal The countertop edge sits typically 1/8” back from the edge of the sink and the sink rim is exposed. Zero Reveal The countertop meets the edge of the sink and fits flush with the sink bowls.