Owner Manual

3
※Hardware Installation
Step 1: Attach Steel Hangers to Your Doors
a.Please choose the correct roller installation according to your roller shape on page
2 above and the illustration below.
Recommended: The Hangers should be between 2”-4” from
the door edge to the center of Hanger.
b.Mark the holes for the hangers at the position shown in the above chart.
Step 2: Cut Floor Guide Slot At The Bottom Of The Door
a.If your door is thick and you want the guide to be hidden in the door, then you
will need to Cut a 5/16” (7mm) wide, 3/4” (20mm) deep slot at the bottom of the door.
Recommended: Cut the slot with a router and slot cutter bit.
5/16”(7mm)
3/4”(20mm)
5/16”(7mm)
3/4”(20mm)
b.If your door is too thin, then you do not need to cut the slot.It could be installed
as the below picture shows.