Installation Sheet

ADJUSTMENTS (USE 5/32" HEX WRENCH FOR THESE ADJUSTMENTS)
SPRING POWER ADJUST (Sizing in accordance to BHMA/ANSI 156.4)
SHOE PLACEMENT
SWEEP SPEED LATCH SPEED BACKCHECK
5100 Series Door Closer - Adjustments
Installation Instructions
Meets ANSI A156.4
6
(Use 5/32" Hex Wrench
for this adjustment)
Adjust latch speed so door
completely closes and latches.
Adjust backcheck accordingly to
prevent excessive opening speed.
OPTIONAL DELAY ACTION
Adjust delay action accordingly to
obtain desired delay time.
Note: Adjust closing time speed
to between 3 and 7 seconds
from 90 to 0. Greater closing
times may be required for
elderly or handicapped.
or
HAGER COMPANIES 139 Victor Street, St. Louis, MO 63104 • [phone] • Fax [phone]
Interior Door Width
24"
(610mm)
30"
(762mm)
34"
(865mm)
38"
(965mm)
48"
(1219mm)
54"
(1372mm)
Size 2
(4ccw)
Size 3
(0)
Size 4
(4cw)
Size 5
(8cw)
Size 6
(12cw)
Size 5
(12cw)
Size 1
(4ccw)
Size 1
(8ccw)
Size 2
(0)
Size 3
(4cw)
Size 4
(8cw)
Exterior (and Vestibule) Door Width
24"
(610mm)
30"
(762mm)
36"
(914mm)
42"
(1067mm)
48"
(1219mm)
Size 3
(0)
Size 4
(4cw)
Size 4
(8cw)
Size 5
(8cw)
Size 6
(12cw)
Size 5
(12cw)
Size 3
(4cw)
Regular Arm &
Top Jamb
Parallel Arm
Regular Arm &
Top Jamb
Parallel Arm
Minimum Door Width (24")
Minimum Door Width (24")
TABLE OF SIZES
Closer is shipped set to size
3. To change the closer size,
use a hex wrench to rotate
the spring power adjust.
Follow the chart to make the
correct numbers of 360°
turns to set the closer size
appropriately for the door
application.
The number of turns is an
approximation and does not
account for environmental or
door hardware affects.
cw = clockwise
ccw = counterclockwise
----
-----
60"
(1524mm)
-
ADJUSTMENT DIAGRAM
DELAY
Flip connecting rod as
shown to increase
closer strength.