Specification Sheet

TOP
LABEL SIDE
HANDING
SCREW *
REVERSIBLE
LATCH BOLT *
TOP
LABEL SIDE
TOP
LABEL SIDE
TOP
LABEL SIDE
OUTSIDE
INSIDE
RH - RIGHT HAND DOOR
LH - LEFT HAND DOOR
RHR - RIGHT HAND REVERSE DOOR
LHR - LEFT HAND REVERSE DOOR **
OUTSIDE
INSIDE
OUTSIDE
INSIDE
OUTSIDE
INSIDE
REFER TO THE MORTISE LOCK INSTALLATION
INSTRUCTIONS FOR FURTHER DETAILS ON CHANGING
THE HANDING.
NOTE: THE LOCK HANDING SCREW MUST ALWAYS BE
ON THE INSIDE OF THE DOOR FOR PROPER
OPERATION OF THE LOCK.
* TO PROPERLY CHANGE HANDING, BOTH THE REVERSIBLE
LATCH BOLT AND HANDING SCREW MUST BE SET
PROPERLY. TO USE THIS GUIDE, ORIENT THE LOCK CASE
AS SHOWN ABOVE. THE TERM "LABEL SIDE" REFERS TO
THE SIDE WITH THE "HOW TO CHANGE LOCK HANDING"
STICKER.
** THE LOCK COMES FROM THE FACTORY PRESET WITH THE
SCREW INSTALLED ON THE LABEL SIDE. IF REQUIRED,
REMOVE THE SCREW AND RE-INSTALL ON THE OPPOSITE
SIDE OF THE LOCK CASE (I.E. RH AND RHR REQUIRE THIS
CHANGE).
REVISIONS
REV. DESCRIPTION DATE
01 ORIGINAL RELEASE 11/28/2007
WEIGHT: 3.02
I-LS00109
-
Material <not specified>
TJS
8/13/07
-
-
MORTISE LOCK HANDING GUIDE
PROPRIETARY & CONFIDENTIAL
THE INFORMATION CONTAINED
IN THIS DRAWING IS THE SOLE
PROPERTY OF HAGER
COMPANIES. ANY REPRODUCTION
INPART OR AS A WHOLE WITHOUT
THE WRITTEN PERMISSION OF
HAGER COMPANIES IS PROHIBITED.
SHEET 1 OF 1
Q.A.
ENG. APPR.
DRAWN
TOLER ANCES:
FRACTIONAL:
0.015"
ANGULAR: MACH:
1 BEND: 1
TWO PLACE DECIMAL: 0.01"
THREE PLACE DECIMAL:
0.004"
DO NOT SCALE DRAWING
FINISH
MATERIAL
A
DWG. NO.
SIZE
SCALE:1:4
HAGER RESERVES
THE RIGHT TO
MAKE DESIGN
CHANGES
WITHOUT NOTICE.
CALL HAGER
ENGINEERING AT
1-800-325-9995
FOR THE LATEST
REVISION DATE
OF TEMPLATE.
3800
REV.
01