Installation Sheet

3800 Series Mortise Lock - Escutcheon

Installation Instructions

I-LS00125

REV 2

Page 4 of 4

STEP 9: INSTALL ARMOR FRONT

A. Secure cylinder by tightening cylinder anchor screw until hand-tight.

B. Tighten two (2) lock case mounting screws.

C. Place armor front in position and install two (2) screws.

STEP 10: INSTALL EMERGENCY BUTTON

A. Snap emergency button into place.

STEP 11: INSTALL COIN TURN

A. Insert coin turn in the vertical position.

STEP 12: INSTALL INSIDE ESCUTCHEON ASSEMBLY

A. Check function and adjust assemblies if necessary.

B. Tighten mounting screws in inner spring insert and escutcheon insert.

C. Place thumbturn in vertical position and push escutcheon flush with face of door.

STEP 13: INSTALL INSIDE LEVER AND OUTSIDE LEVER

OUTSIDE LEVER DOES NOT CONTAIN A KEEPER RELEASE HOLE. ONLY INSIDE LEVER CONTAINS A KEEPER RELEASE HOLE.

A. Align outside and inside levers with sleeve and push until know keeper engages with hole.

Note: Outside lever with no keeper hole. Only inside lever with keeper hole.

Emergency

Button

Coin Turn

Keeper Hole

Inside Lever

Outside Lever