Specification Sheet

A
ROSE
LATCH LOCKING
CAM
C
ROSE
LATCH LOCKING
CAM
B
ROSE
LATCH LOCKING
CAM
DETAIL B
CAM KEYWAY MUST
FACE TO THE RIGHT
DETAIL A
DETAIL C
CAM KEYWAY MUST
FACE TO THE RIGHT
NOTE: USE THE FOLLOWING INSTRUCTIONS ONLY
IF THE LOCKING CAM LOOKS LIKE THE PICTURE
TO THE LEFT.
3670 LEVERSET
USING A SCREWDRIVER, ROTATE THE CAM 1.
CLOCKWISE UNTIL IT STOPS. IT SHOULD
LOOK LIKE DETAIL "A" INSIDE THE LOCKBODY.
INSERT THE KEY INTO THE CYLINDER AND 2.
ROTATE THE TAILPIECE 90 DEGREES
CLOCKWISE.
MAKING SURE THAT THE TAILPIECE ALIGNS 3.
WITH THE LOCKING CAM, INSTALL THE LEVER
ONTO THE LOCKBODY SHAFT UNTIL THE
LEVER SNAPS INTO PLACE.
INSIDE LEVER - USING A SCREWDRIVER, ROTATE 1.
THE CAM UNTIL THE KEYWAY FACES TO THE
RIGHT AS SHOWN IN DETAIL "C".
OUTSIDE LEVER - USING A SCREWDRIVER, 2.
ROTATE THE CAM UNTIL THE KEYWAY FACES TO
THE RIGHT AS SHOWN IN DETAIL "C".
INSERT THE KEY INTO THE INSIDE CYLINDER AND 3.
ROTATE THE TAILIECE 90 DEGREES TO MATCH
CAM PROFILE. INSERT LEVER UNTIL IT SNAPS
INTO PLACE.
INSERT THE KEY INTO THE OUTSIDE CYLINDER 4.
AND ROTATE THE TAILPIECE 90 DEGREES TO
MATCH THE CAM PROFILE. INSTALL THE LEVER
UNTIL IT SNAPS INTO PLACE.
USING A SCREWDRIVER, ROTATE THE CAM 1.
UNTIL THE KEYWAY FACES TO THE RIGHT AS
SHOWN IN DETAIL "B".
INSERT THE KEY INTO THE CYLINDER AND 2.
ROTATE THE TAILPIECE 90 DEGREES.
MAKING SURE THAT THE TAILPIECE ALIGNS 3.
WITH THE LOCKING CAM, INSTALL THE LEVER
ONTO THE LOCKBODY SHAFT UNTIL IT SNAPS
INTO PLACE.
USING A SCREWDRIVER, ROTATE THE CAM 1.
CLOCKWISE UNTIL IT STOPS. ROTATE THE CAM
BACK THE OTHER DIRECTION UNTIL IT LOOKS
LIKE THE PICTURE TO THE LEFT.
INSERT THE KEY INTO THE CYLINDER AND 2.
ROTATE THE TAILIECE CLOCKWISE 90
DEGREES.
INSTALL THE LEVER ONTO THE LOCKBODY 3.
SHAFT UNTIL IT SNAPS INTO PLACE.
3470/3570/3473/3573/3579 LEVERSET
3495 LEVERSET
3470/3473/3495/3570/3573/3579/3670 LEVERSET TIMING INSTRUCTIONS
REV: 07 DRAWING NO: I-LS00310 SHEET 1 OF 2
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 - [phone] - Fax [phone]