Installation Sheet

3100 Series ANSI Grade 1 Deadbolt
Installation Instructions
Meets ANSI 156.5
I-LS00763
REV 2 Page 2 of 2
5. INSTALL SINGLE CYLINDER (SKIP TO STEP 6 IF USING DOUBLE CYLINDER)
A. Retract deadbolt to unlock position. Insert exterior tail piece
horizontally through latch crank.
6. INSTALL DOUBLE CYLINDER
A. Retract deadbolt to unlock position. Insert exterior tail
piece horizontally through latch crank.
B. First, use hex wrench to remove inside thumb turn, remove
washer and separate rose from inside rose collar.
EXTERIOR CYLINDER
EXTERIOR TAIL PIECE
LATCH CRANK
DEADBOLT
CORRECT KEYWAY
POSITION
INSIDE ROSE COLLAR
INSIDE ROSE
HEX WRENCH
INSIDE THUMB
TURN
C. Press exterior cylinder flush against door. Install
inside rose collar and tighten mounting screws. Press on
rose, washer, and thumb turn. Use hex wrench to securely
tighten thumb turn in place.
MOUNTING SCREWS
WASHER
INSIDE THUMB TURN
HEX WRENCH
INSIDE ROSE
INSIDE ROSE COLLAR
EXTERIOR
CYLINDER
B. Press exterior cylinder flush against door. Install
interior tail piece vertically through latch crank. Press
interior cylinder flush against door and tighten mounting
screws.
EXTERIOR CYLINDER
TAILPIECE
LATCH CRANK
DEADBOLT
EXTERIOR CYLINDER
INTERIOR TAILPIECE
INTERIOR CYLINDER
MOUNTING SCREWS