Installation Sheet

1.62
41.2
DOOR
EDGE
DRILL (2) 1/2"[12.7] DIAMETER HOLES THRU THE FACE OF THE DOOR. (FOR 1.
WOOD DOOR, DRILL HALF WAY THRU BOTH SIDES OF THE DOOR TO AVOID
SPLINTERING.)
INSERT ONE MOUNTING PLATE THROUGH ONE ROSE LINER SO THEY SIT 2.
FLUSH.
TIGHTEN THE ROSE LINER AND MOUNTING PLATE TOGETHER USING (2) 3.
1/2"[12.7] LONG MACHINE SCREWS AND (2) THREADED COUPLERS. SEE
FIGURE 1.
INSERT SECOND MOUNTING PLATE THROUGH SECOND ROSE LINER SO 4.
THEY SIT FLUSH.
INSERT ASSEMBLY WITH THE THREADED COUPLERS INTO THE HOLES IN 5.
THE DOOR.
HOLDING THE THREADED COUPLER ASSEMBLY TIGHT AGAINST THE DOOR, 6.
PLACE THE SECOND ASSEMBLY UP AGAINST THE INSIDE FACE OF DOOR.
INSERT (2) MACHINE SCREWS THRU THE HOLES IN ROSE LINER.
TIGHTEN ASSEMBLY TO THE DOOR USING (2) MACHINE SCREWS (MACHINE 7.
SCREWS SHOULD TIGHTEN TO THE THREADED COUPLERS INSIDE THE
DRILLED HOLES IN THE DOOR). SEE NOTE FOR SCREW DETAILS.
MAKE SURE BOTH SIDES ARE COMPLETELY TIGHTENED DOWN AND THEN 8.
INSTALL BOTH ROSES OVER THEIR ROSE LINERS.
INSERT BOTH LEVERS UNTIL THEY SNAP SECURELY IN PLACE. 9.
MOUNTING
PLATE
ROSE LINER
ROSE
LEVER
THREADED
COUPLER
SEE NOTE:
MOUNTING
PLATE
ROSE LINER
ROSE
LEVER
OUTSIDE
FACE
FIGURE 1:
WHEN TIGHTENED DOWN,
COUPLER WILL TIGHTEN TO
THE ROSE LINER. COUPLER
MUST SIT IN THE HOLE
OF THE MOUNTING PLATE
SO THAT IT CANNOT
TWIST.
DIMENSIONS IN [ ] ARE IN MILLIMETERS
NOTE:
FOR 1-3/8"[35] THICK DOOR, USE 1"[25.4] LONG MACHINE SCREWS.
FOR 1-3/4"[45] THICK DOOR, USE 1-3/8"[35] LONG MACHINE SCREWS.
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 - [phone] - Fax [phone]
2527 DUMMY INSTRUCTIONS
BACK TO BACK MOUNTING
SHEET 3 OF 3 DRAWING NO: I-LS00890 REV: 01