Operation Manual

10
Maintenance and care
Changing the water filter
Take off the cap of the tank. Hold the
metal piece (A) in one hand and screw
off the water filter (B). Now you can
screw on the new filter.
Cleaning function
Use the cleaning function, if the nozzle
is blocked.
Turn the unit off. Remove the water
filter at first. (For its instructions see
paragraph above) . Fill the tank with
distilled water. Close the tank and put it
back into the unit.
Adjust the amount of spray (button (1)
on maximum. Now press button (9). In
the display you will find the message
CL, if requested, you could cancel the
process by pushing button (8). The
complete cleaning process will last
three minutes.
During the cleaning process, the water
will be blowed out of the whole hosing
system. Parts of dirt are rinsed into the
tank. Do not use this water again, but
clean the tank immediately after realiz-
ing a blockage in the nozzle. Otherwise
the dirt parts might stick together.
Clean the water filter carefully and put it
back in the adapter. Refill the tank with
new water.
Use the cleaning function only, if the
nozzle is blocked. Do not use the
function, it the unit works properly.
7
Usage
Insert the bur
The handpiece is equipped with an
chuck which can hold all burs with a
diameter of 2.35 mm and usually are
used in the fields of podiatry. To open
the chuck, push the black knob forward
with your thumb and leave it there. Now
insert the tool as far as possible. Pull
back the black knob and the tool will be
clamped.
Adjusting the speed
Put the handpiece back in the hand-
piece holder or keep it in your hand.
Switch ON the unit with switch (8). Now
you can adjust the requested speed
with the switch (3) & (4). Choose the
direction with switch (6).
Spray
Turn on the spray function while push-
ing switch (2). Now the spray system
will be filled automatically and a strong
spray stream will be blowed out of the
handpiece for the first 15 sec. Then
you can adjust the requested spray
stream while turning knob (1).
When turning off the unit or the spray
function, the spray liquid is pumped
back completely into the tank from the
hoses. With this process, a bubbling
can be heard in the tank .
For security reasons, only
change the tool if the handpiece
is turned off.
clamped
opened