User Manual Instruction Manual

Figure 2 Back overview

1 Power cord connector 5 Air purge fitting

2 Fuse holder 6 Recorder output jack for a chart

recorder (0 to 1 V output)

3 Power switch 7 Remote cable jack for flow valve

module connection to the automatic

flow cell (low pressure)

4 DB9 connector for RS232 cable

Product components

Refer to Figure 3 to make sure that all components have been received.

If any of these items are missing or damaged, contact the manufacturer

or a sales representative immediately.

Figure 3 Instrument components

1 2100AN IS turbidimeter 6 Gelex

secondary turbidity

standardization kit

2 Oiling cloth 7 Dust cover

3 Six 1" sample cells (30 mL) with

caps

8 Printer paper roll (2x)

4 Silicone oil 9 Power cord

5 StablCal

Calibration kit

Supplied with 4790100 only.

Do not remove the plastic wrapper from the paper rolls until the paper is

installed.

Installation

D A N G E R

Multiple hazards. Only qualified personnel must conduct the tasks

described in this section of the document.

English 7