User Manual

9
Section 3 Installation
DANGER
Only qualified personnel should conduct the tasks described in this section of the
manual. The 1720E/sc100 product configuration is not intended for installation in
hazardous locations.
3.1 Connecting/Wiring the Sensor to the sc100 Controller
3.1.1 Attaching a sc Sensor with a Quick-connect Fitting
The sensor cable is supplied with a keyed quick-connect fitting for easy attachment to the
controller, see Figure 2. Retain the connector cap to seal the connector opening in case
the sensor must be removed. The 1720E sensor cable may be extended by a maximum of
7.62 m (25 ft), see Replacement Parts and Accessories on page 33.
Figure 2 Attaching the Sensor using the Quick-connect Fitting