Assembly Instructions

ManualsBrandsHabitat ManualsDining room furnitureQuattro Grey Dining Table & 4 Grey Chairs

Quattro Chair

Assembly Instructions - Please keep for future reference 814/3859

760/7286

Important - Please read these instructions fully before starting assembly

If you need help or have damaged or missing parts, call the Customer Helpline:

Argos = 0345 640 0800

Issue 1 -05/09/20

Dimensions

Width - 52cm

Depth - 49cm

Height - 71cm

Summary of content (5 pages)

PAGE 1
Quattro Chair Assembly Instructions - Please keep for future reference 814/3859 760/7286 Dimensions Width - 52cm Depth - 49cm Height - 71cm Important - Please read these instructions fully before starting assembly If you need help or have damaged or missing parts, call the Customer Helpline: Argos = 0345 640 0800 Issue 1 -05/09/20
PAGE 2
Safety and Care Advice Important - Please read these instructions fully before starting assembly • Check you have all the components and tools listed on the following pages. • During assembly do not stand or put weight on the product, this could cause damage. • Remove all fittings from the plastic bags and separate them into their groups. • Assemble the item as close to its final position (in the same room) as possible.
PAGE 3
Components - Parts If you have damaged or missing components, call the Customer Helpline: 0345 640 0800 Please check you have all the parts listed below 1 2 Seat 3 Upper Leg Lower Leg Components - Fittings Please check you have all the fittings listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.
PAGE 4
3 3 Assembly Instructions Step 1 2 3 Assembling legs Attach the upper leg to the lower leg 2 as shown and fix through holes using bolt A , spring washer C and flat washer D . Tighten the bolt using allen key E . 3 2 E A C D 2 2 3 3 A C D 2 3 Step 2 Assembling the seat Place the seat 1 face down on a flat protected surface. Position the legs 2 & 3 on the seat then align and fix through holes using bolts A , spring washers C and flat washers D . Tighten the bolts using allen key E .
PAGE 5
Assembly Instructions Step 3 Attaching foot pads Remove backing from foot pads F and carefully position on the bottom of the legs 2 & 3 as shown. F F 3 F 2 F Carefully turn the chair upright after assembly. Assembly is complete.