Assembly Instructions

A B C
D
G
E F
3
R uler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
105
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
The screws length is measured from the head to the point (30mm screw shown).
Please check you have all the fi ttings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fi ttings
may be supplied than are required.
Components - Fittings
H
Plastic support x 3
12mm Screw x 12
14mm Screw x 815mm Screw x 16
30mm Screw x 10
15mm Locking nut x 1039mm Locking pin x 15
30mm Dowel x 6
I
J K L
Right inside runner x 1Right outside runner x 1Door hinge x 4
12mm Locking nut x 5
M N O
P Q R
Left inside runner x 1Left outside runner x 1
Door pad x 4
Shelf support x 4Nail x 16 Support cover x 4
S T
Wall plug x 2 Handle x 4
(This screw is included in
the runners bag)
(This screw is included in
the door hinges bag)
Wall strap x 2
U
(This screw is
included in the
wall strap bag)
x 2