Instruction Manual

Important
For your safety, this product must be installed in accordance with wiring regulations from the Institute
of Engineering and Technology (IET) and current local Building Regulations.
If in any doubt, or where required by the law, consult a competent person who is registered with an
electrical self-certification scheme. Further information is available online or from your Local Authority.
To prevent electrocution, switch off at the mains supply before installing or maintaining this fitting.
Ensure other persons cannot restore the electricity, supply without your knowledge.
To avoid damage to concealed wiring during installation, establish the direction of the supply cable
before drilling fixing holes.
Always be sure to use the correct type and wattage of bulbs as indicated on the fitting. Never exceed
the wattage stated.
When changing the bulb, always switch off at the mains and allow the old bulb to cool down before
handling. Dispose of used bulbs carefully.
This fitting is Class II appliance.
The luminaire is designed for indoor use only.
฀
Before removing the existing fitting, carefully note the position of each set of cables. If there are
loop in cables that are not connected to the light, they must be terminated separately and not
connected to the fitting.
.
IMPORTANT: To avoid overheating, do not exceed the maximum wattage as
stated on the product.
Instruction for use
1. Switch off the mains power supply.
2. Before replacing the bulb, allow it to cool down for at least 10 minutes.
3. Never touch the bulb with your fingers directly, cover it with a cloth.
4. Loosen the bulb and remove it from the lamp.
5. Replace a new bulb with same voltage and wattage ( LED Max.8W）.Products should not
be disposed of with household waste. Please recycle where facilities exist. Check with your
local authority for recycling advice.
2
2
1. Switch off the electricity supply at the fuse board.
3. Using the bracket as a template, mark and drill fixing holes in the wall .Screw the bracket onto the
wall using suitable screws (Fig. 1b)
4. Each L, N and Earth cables should be fully covered by the small sleeving (provided); then fasten by
using the plastic belt (provided ) to make sure the small sleeving are fixed well on the cables. (Fig. 2)
5.
Ensure the electrical connections are covered with suitable insulation tape.
6.Connect the supply wires to the terminal block in the corresponding L / N / E positions. (Fig. 3)
8. Fit the bulb to the lamp holder. The type and wattage is indicated on the fitting.The wattage
indicated must not be exceeded.
9. Install the glass shade on the lamp holder.(Fig. 4)
Maintenance
This luminaire is designed for indoor use only . Do not use polish or abrasive cleaner - use a soft
dry cloth to clean the product
.
2. Unscrew the two side screws to remove bracket from the wall plate. (Fig. 1a)
10.
Switch on the electricity supply at the fuse board．
Offer fitting up onto the bracket and push any excess cable into the wall void. Secure the wall cup
into position using the 2 screws removed earlier. Take care not to trap or damage wiring.
7.