User Manual

1. Gateway Installation
1) Unscrew and open the bottom cover. And
insert a simcard.
2) To configure, connect a serial cable between a
gateway and a PC and run the configuration
software. And power on the gateway.
① Start command is transmitted from a gateway
<Picture1: Simcard Insert>
to configuration software.
If there is any expected response from PC, communication for set-up mode is on.
Otherwise, regular log is transmitted from the gateway to the configuration software.
a. Check ‘setting’ in the configuration software: The set-up mode is activated and
log is also transmitted to the configuration software.
b. Uncheck ‘setting’ in the configuration software: Only log transmission is activated.
2. Pairing
1) Power off.
2) Select the pairing switch and power on.
① N: Normal mode (No pairing)
② P1: Pairing as a slave. Used for A&D weight
scale.
③ P2: Pairing as a master. Used for IEM B/P
monitor, J&J glucometer and ForaCare thermometer.
<Picture3: Pairing Switch>
* After pairing is done, it turns to normal operation mode.
2 ) LED
① On pairing, Reading LED in GREEN is on.
② At the success of pairing, Reading LED blinks GREEN two times.
③ At the failure of pairing, Reading LED blinks RED five times.
4) Device pairing method
① A&D weight scale: Select P1 and measure a weight with the device
② IEM B/P monitor: Select P2 and change into the pairing mode
③ J&J glucometer: Select P2 and change into the pairing mode
④ FORA thermometer: Select P2 and measure a temperature with the device