User's Manual

0. Overview
This document describes instructions regarding the H3 CDMA gateway (H3G-650, H3
System) and the related components. This document includes
- How to install and configure the H3 CDMA gateway
- How to use the H3 CDMA gateway
- How to setup a server system for the H3 CDMA gateways
1. Gateway installation
1) Preparation for deployment
A. SIM card
i. Unscrew and open the bottom cover.
And insert a SIM card.
B. Gateway configuration
i. Turn off the gateway.
ii. Connect a serial cable (provided by H3
System) to a gateway and a PC.
iii. Run the configuration software.
iv. Turn on the gateway.
v. Configure the gateway with the configuration software. For the details, please
see the section below, “Gateway configuration.”
C. Pairing and testing
i. Pair with devices. Please see “Pairing” section below.
ii. Take readings and confirm if the readings are successfully delivered to a server.
Please see “Measurement and data transmission” section.
D. Final inspection
i. Confirm the mode selection switch at “N.” If not, set the switch at “N.”
ii. Prepare dry cells for backup batteries.
iii. Close the bottom cover.
2) Installation at user’s home
A. Place a gateway at a suitable place.
B. Connect a power adapter.
C. Insert dry cells if required.
2. Gateway configuration
1) Components
A. A serial cable provided by H3 System
B. Configuration software
i. For admin: Serial numbers can be modified.
ii. For user: Serial number change is not allowed.
2) Descriptions
Figure 1. SIM card insertion