User's Manual

How to Use

1. [Preparation]

 Insert batteries.

Open the cell cover to place AAA 1.5V 2 EA while checking the polarity (+,-) and

then close the cover.

 Connect the cable to a glucometer

2. [Bluetooth pairing]

Bluetooth pairing is an authentication process between a Bluetooth adapter and a target

device that readings are supposed to be sent to.

 The following procedure should be performed to pair the Bluetooth adapter with a

NEW target device.

 If Bluetooth pairing fails, the latest pairing info is preserved. And the Bluetooth

adapter can send readings to the latest paired device.

 If you try to pair with the latest paired device, the Bluetooth adapter considers it as

a failure. This feature may make confusion. So it is recommended not to pair with

already paired device again.

 There are two ways to make the device be pairing mode. For details, please see the

table below. The firmware version 1.2 or later supports both.

Pairing method

With Hidden button

With Red button

Supported firmware

version

All

Version 1.2 or later versions

Action

Press the Hidden button

Press and hold the Red button on

the top cover until the LED turns

RED (for more than 5 seconds)

BT device name

AMC_JandJ

H3GMA_(Model)_(FW

version)_(BT address)

Pin CODE

1234

9314

* Notes

Model: ROCHE

FW version: X.X (e.g. 2.0)

BT address: The last 3 hexas, that is, 6 digits. For example, A1B2C3.

Table 2-1