Instructions

22 | Designated use
1. DESIGNATED USE
The device can switch a connected unit (max. 230V~/50Hz, max. 6 A,
1000 VA) based on temperature control on or off. The ON-OFF temperature
can be freely adjusted between –55°C to +125°C by increments of 1°C.
A red LED indicates „heating“, a yellow „cooling“, a further illuminates when the
relay is switched. Any other use as defined is not allowed.
2. GENERAL SAFETY INSTRUCTIONS
– This device should not be handled or installed by persons with reduced
physical, sensory or mental capabilities or lack of experience (including
children) other than if supervised by a trained, responsible person.
– Children may not play with this device and should be supervised when
present.
– This device may only be connected to a properly installed power socket. The
voltage must match the specifications depicted on the nameplate of the unit
or mentioned in this instruction manual.
– Keep the mains power cord away from sharp edges, moisture, heat or oil.
– Do not connect the device if the power cord is damaged. In order to avoid
a hazard or electrocution, a damaged power cord must be replaced
immediately by our service centre or a similarly qualified person.
– If the power cord is damaged unplug the device immediately and replace the
power cord accordingly by our service centre or a similarly qualified person.
– Unplug the device if it is not used over a longer period of time.
– Keep the packing material and the plastic bags away from infants. There is
a danger of suffocation.
– When installing the device, install all cables so that they do not become a
tripping hazard or can accidentally be pulled out.
– When disconnecting the device from the mains, pull the plug out of the socket.
Do not pull at the power cord.
3. SAFETY INSTRUCTIONS
When handling electrical devices, the VDE regulations have to be applied.
Especially VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and VDE 860.
– This device may not be modified in any way. The CE conformity has been
declared and proven and the corresponding document is deposited with the
manufacturer.