User Manual
disconnect the Rx wires from receiver and then connect it to LED program card.
For WP-S10C, WP-S10D, WP-S10DS, WP-S10E, WP-10BL60 ESC, the program port is multiplexed with the
cooling fan port, please disconnect the cooling fan, and then use program cable to connect the fan port of the
ESC to the LED program card.
【TROUBLE SHOOTING】
Trouble
Possible Reason
Solution
After power on, motor can’t work, no
sound is emitted
The connections between
battery pack and ESC are not
correct
Check the power connections
Replace the connectors
After power on, motor can’ t work, but
emits “beep-beep-, beep-beep-” alert
tone. (Every “beep-beep-” has a time
interval of 1 second )
Input voltage is abnormal, too
high or too low.
Check the voltage of the battery
pack
After power on, motor can’ t work, but
emits “beep-, beep-, beep-” alert tone.
(Every “beep-” has a time interval of
about 2 seconds). And the red LED
solid lights
Throttle signal is abnormal
Check the transmitter and the
receiver
Check the wire of the throttle
channel
After power on, motor can’ t work and
the red LED blinks very quickly
The neutral point of the throttle
channel is changed
Calibrate the throttle range for the
ESC again, or adjust the trimmer of
throttle channel (on the transmitter)
to change the neutral point.
The motor runs in the opposite direction
The wire connections between
ESC and the motor need to be
changed
Swap any two wire connections
between the ESC and the motor.
The motor suddenly stops running
while in working state
The throttle signal is lost
Check the transmitter and the
receiver
Check the wire of the throttle
channel
The ESC has entered the Low
Voltage Protection Mode
Replace the battery pack
Random stop or restart or irregular
working state
Some connections are not
reliable
Check all the connections: battery
pack connections, throttle signal
wire, and motor connections, etc.
There is strong electro -
magnetic interference in flying
field.
Reset the ESC. If the function could
not be resumed, you might need to
move to another area to run the car.
5