DECLARATION Thanks for purchasing our electronic speed controller (ESC). The power system for RC model can be very dangerous, so please read this manual carefully. In that we have no control over the correct use, installation, application, or maintenance of our products, no liability shall be assumed nor accepted for any damages, losses or costs resulting from the use of the product.
Features: 1. 2. 3. 4. 5. 6. 7. 8. Water-proof and dust-proof. The ESC can work under water for a short time. (Please remove the cooling fan when running car in water, and after running, please make the ESC clean and then dry it to avoid the oxidation to copper connectors) Specially designed for RC car and truck, with excellent start-up, acceleration and linearity features. Drive sensorless brushless motors. 2 running modes (“Forward with brake” mode, “Forward/Backward with brake” mode).
the“ Reverse” direction, and then the motor will run oppositely. Please calibrate the throttle range again after changing the direction of throttle channel. 2. Throttle Range Setting (Throttle Range Calibration) In order to make the ESC match the throttle range, you must calibrate it when you begin to use a new ESC, or a new transmitter, or after changing the settings of the neutral position of throttle channel, ATV or EPA parameters, otherwise the ESC cannot work properly.
3. Throttle signal loss protection: The ESC will cut off the output power if the throttle signal is lost for 0.2 second. Program the ESC: PROGRAM THE ESC 1. Program Method Note: In the program process, the motor will emit “Beep” tone when the LED is flashing. The 5th programmable item is represented by 5 short Beeps (that is, “BBBBB”).
2. Programmable Items list Programmable Items 1.Running Mode 1 2 Forward with Brake Forward/Reverse with Brake 2.Drag Brake Force 3.Low Voltage Cut-Off Threshold 5 6 7 8 30% 40% 0% 5% 10% 15% 20% 25% Non-Protection 2.6V /Cell 2.8V /Cell 3.0V /Cell 3.2V /Cell 3.4V /Cell Level1 (Soft) Level2 Level3 Level4 (Very Aggresive) 25% 50% 75% 100% 4.Start Mode (Punch) 5.
disconnect the Rx wires from receiver and then connect it to LED program card. For WP-S10C, WP-S10D, WP-S10DS, WP-S10E, WP-10BL60 ESC, the program port is multiplexed with the cooling fan port, please disconnect the cooling fan, and then use program cable to connect the fan port of the ESC to the LED program card. TROUBLE SHOOTING Trouble After power on, motor can’t work, no sound is emitted After power on, motor can’ t work, but emits “beep-beep-, beep-beep-” alert tone.
