J3 Navy Cub Instruction Manual

5
Install the rudder plate into
the vercal tai l.
Install the control horn to the
elevator using the 1.7X15mm
screws provided.
Install the control horn to
the rudder using the
1.7x15mm screws provided.
Install the horizontal tail onto the fuselage with screw the 2 off M3x30mm screws provided.
4
Install the vercal tail using the M3x45mm and the M3x40mm screw provided.
5
Connect the rudder pushrod to the tailwheel control arm as
shown.
8
1
2
3
Assemble the tailwheel parts using a medium CA glue.
Install the tailwheel assembly using
the 2.6x8mm screws provided.
6
7
ASSEMBLY OF HORIZONTAL TAIL, VERTICAL TAIL & TAIL WHEEL:
Set the elevator at neutral
and connect the pushrod.