J3 Navy Cub Instruction Manual

10
||Motor runs
backwards
1. Motor/
ESC connection error
1. Swap around any 2 of
the 3 ESC/motor wire
connections
Servos not
operating
properly
1. The servo leads are connected
to the Rx incorrectly.
2. The servo is damaged.
1. Make sure the servo leads
are connected properly.
2. Replace servo.
Difficult to trim
1. Control surfaces not centered.
2. CoG is not in the correct
position.
1. A
djust the trims on the
transmitter.
2. Re-position the battery
suggested.