User Manual

BRUSHLESS CONTROLLERS
FOR AIRCRAFT
Thanks for purchasing our H.King series Electronic
Speed Controller (ESC) for aircraft. This product in
corporates the latest technological developments.
You have got a very ef cient controller for brushless
motors use. Our priority was reliability and simple to
use. All H.King controllers are ready to y straight from
the package, no programming necessary. They are
defaulted to AUTO LIPO detect and no brake. Should
users wish to modify these settings, they may do so
Even if programming sequences of H.King speed
Controllers are particularly logical and therefore very
easy, using and operating requires some knowledge
and a few basic skills. Please read through instructions
entirely before attempting to operate with these
using their transmitter .
electronic devices.
INSTRUCTION MANUAL
1
WE STRONGLY RECOMMEND GETTING
PARTICULARLY CLOSE ATTENCTION TO OUR
SAFETY NOTES.
Understand that an electric motor that is
connected to a battery and speed control may
start unexpectedly and cause serious injuries.
Always treat them with necessary respect.
Keep the propeller away from your body and
others at all times.
We suggest that you remove the propeller
when you are working on the plane with the
battery connected.
Please observe all local laws regarding the
ying of remote control aircraft.
Never y over others or near crowds.
SAFETY NOTES:
!
High power system for RC model can be very
dangerous, so we strongly suggest you read this
manual carefully. In t hat we have no control over the
correct use, installation, application, or maintenance
of our products, no liability shall be assumed nor
accepted for any damages, losses or costs resulting
from the use of the product. Any claims arising from
the operating, failure or malfunctioning etc. will be
denied. We assume no liability for personal injury ,
property damage or consequential damages
resulting from our product or our workmanship. As
far as is legally permitted, the obligation to
compensation is limited to the invoice amount of the
!
!
!
!
aected product.
2
You will need to solder connectors on your H.King
controller.
Connect your H.King ESC
Fly your H.King ESC
Please refer to the diagram above.
Battery
Pack
Receiver
Remove the red
wire if you need to
disable BEC
Solder or use
connectors
Motor
H.King ESC
Double-check your battery polarity and connections
before plugging a battery into your controller .
There is no polarity for the three motor wires. If the
motor spins the wrong way when power is applied,
swap any two of the motor side connections and it
will then spin properly . Y ou may also use
programming function, described below, to reverse
the rotation via the controller's software.
NOTE TO FUT ABA TRANSMITTER USERS You
may have to reverse the throttle direction of your
radio. Please see your radio's instructions on
how to make this change.
Your H.King ESC comes ready to y with Lithium
Polymer type batteries. No settings changes are
needed. T o y, turn your transmitter on before
connecting your H.King ESC to the motor battery.
When you connect the motor battery to the H.King
ESC, you will hear an initialization tone from the
motor and a series of beeps telling you how many
Lithium Polymer cells in series are in your battery
pack, and the servos will be active. Make sure that
the number of beeps matches the number of cells
in your pack. If it doesn't, make sure
your pack is fully
charged. The H.King ESC will not arm unless you
move your throttle stick to the lowest position. When
the H.King ESC receives the low throttle command, it
will arm and play a double tone through the motor,
indicating it is armed and now ready to run. If this is
the rst time you are running the controller, advance
the throttle slowly to ensure that the propeller
rotation is correct. If it isn't, correct as described
above. above.
3
10A 20A
35A 50A