Technical Specifications

H&C Products Group Technical Service 1.800.867.8246 Page 2 of 2
101 W. Prospect Avenue www.hcconcrete.com
Rev. 10/17
Cleveland, Ohio 44115 PDS ID: 111.551
PHYSICAL PROPERTIES
Physical Properties and Characteristics
Property
Test Method
Value
VOC
EPA Method 24
0 g/L
Compressive Strength
ASTM C-109
3 Hours 3090 PSI
24 Hours 4850 PSI
28 Days 6042 PSI
Set Time
Initial 7-20 Mins
Final 15-30 MIns
Weight per Gallon
ASTM D1475
22 - 25 lb/gal
ORDERING INFORMATION
White Part Number/SMIS
5lb, In 1-gal pail 60.100709-99 /6507-12326
TECHNICAL SERVICES
The information and recommendations set forth in this product
data sheet are based on tests conducted by or on behalf of
H&C Products Group and The Sherwin-Williams® Company.
Such information and recommendations set forth herein are
subject to change and pertain to the product offered at the
time of publication. Consult your H&C or Sherwin-Williams
representative to obtain the most recent product data sheet.
For technical assistance, call 1-800-867-8246 or visit
www.hcconcrete.com.
CAUTION
CAUTIONS CONTAINS CRYSTALLINE SILICA & PORTLAND
CEMENT. Use only with adequate ventilation. To avoid
overexposure, open windows and doors or use other means
to ensure fresh air entry during application and drying. If you
experience eye watering, headaches, or dizziness, increase
fresh air, or wear respiratory protection (NIOSH approved)
or leave the area. Adequate ventilation required when sanding
or abrading the dried film. If adequate ventilation cannot be
provided wear an approved particulate respirator (NIOSH
approved). Follow respirator manufacturer's directions for
respirator use.
FIRST AID: If swallowed, call Poison Control Center, hospital
emergency room, or physician immediately.
DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE.
Abrading or sanding of the dry fi lm may release crystalline silica
which has been shown to cause lung damage and cancer
under long term exposure. WARNING: This product contains
chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm. DO NOT TAKE
INTERNALLY. KEEP OUT OF THE REACH OF CHILDREN.
LIMITED WARRANTY
Seller’s and manufacturer’s only obligations shall be to replace
such quantity of product proved to be defective. Neither seller
nor manufacturer shall be liable for any injury, loss or damage,
direct or consequential, arising from the applicator’s inability to
use the product for his/her intended use. The user assumes all
risk and liability.