Technical Specifications

H&C Products Group Technical Service 1.800.867.8246 Page 1 of 2
101 W. Prospect Avenue www.hcconcrete.com Rev. 10/17
Cleveland, Ohio 44115 PDS ID: 111.551
PRODUCT DESCRIPTION
H&C® CONCRETEREADY® Single Componet Quick Patch &
Repair is a single component cement based chemical
patching compound system providing a workable, no-slump
patch that sets quickly for quicker return to service. Just
add water.
FEATURES & BENEFITS
 Can be used virtually on all bare concrete.
 Application can be made easily and quickly, producing a
bond stronger than the surrounding concrete.
 Excellent for use in repairing all types of concrete
structures.
RECOMMENDED USES
H&C CONCRETEREADY Single Componet Quick Patch & Repair
is formulated for use on concrete and masonry surfaces
including Driveways, Garage Floors, Walkways , Patios and
Pool Decks.
COVERAGE RATES
5 pounds will equal approximately .045 cubic feet, or 1.2
square feet at ½” depth. Maximum thickness is approximately
1”. For thicker applications add coarse sand or pea gravel at
rate of ½ lb to 1 lb of dry mix to prevent excessive shrinkage
JOBSITE TEST SECTION
Due to the wide variety of substrates, preparation methods,
application methods and environments, it is important to
create a test sample.
LIMITATIONS
Protect From Freezing.
SURFACE PREPARATION
Remove all laitance, efflorescence, chemical contaminants,
grease, oil, old paint, and other foreign matter. The prepared
surface must be clean and structurally sound. The surface may
require profiling. Sand blasting, grinding or shot blasting may
be necessary to get to bare concrete. Substrate must be 50°F
and rising before installation. Surface at 90°F and above must
be cooled before installation. Dampen area with fog tipped
sprayer before using, leaving no puddles.
INSTRUCTIONS
Concrete or masonry surfaces should be dampened after
cleaning, before
application of H&C CONCRETEREADY
Single Componet Quick Patch & Repair. Any excess water
should be blown or
swept away. Apply slurry bond coat
consisting of H&C
CONCRETEREADY Single Componet
Quick
Patch & Repair mixed loosely with water with a brush to the
host surface not allowing it to dry prior to application of the
patching coat. H&C CONCRETEREADY Single Componet Quick
Patch & Repair is mixed by adding the dry mixture to the
proper amount of clean water (approx. 1 pt. per 5 lb.) and
mixed thoroughly using a suitable paddle mixer or by hand
trowel for smaller amounts. Do not mix for more than one
minute. Mix no more material than can be placed in ten
minutes. No tempering with additional water should be
attempted. Begin application of H&C CONCRETEREADY Single
Componet Quick Patch & Repair immediately after mixing with
water and work thoroughly into surface of area to be filled. Do
not overwork. Minimize troweling.
CLEAN UP
Clean up is simple and easy with soap and water. Rinse tools
before material hardens.
DISPOSAL
Comply with all applicable local, state and federal rules and
regulations for powder, mixed and cured product, the
packaging and mixing containers.
H&C® CONCRETEREADY®
SINGLE COMPONENT
QUICK PATCH AND REPAIR
TOOLS REQUIRED
• 1/2” drill – must be slow or variable speed drill to control the
shear and mixing speed
• Mixing paddle
• 5 gallon pail
•
Tape and paper to mask all areas for protection
• Concrete Broom