SDS

Section 6. Accidental release measures
Move containers from spill area. Approach release from upwind. Prevent entry into
sewers, water courses, basements or confined areas. Avoid dust generation. Do not
dry sweep. Vacuum dust with equipment fitted with a HEPA filter and place in a closed,
labeled waste container. Dispose of via a licensed waste disposal contractor. Note:
see Section 1 for emergency contact information and Section 13 for waste disposal.
Large spill
:
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Store locked up. Keep container tightly closed
and sealed until ready for use. Containers that have been opened must be carefully
resealed and kept upright to prevent leakage. Do not store in unlabeled containers.
Use appropriate containment to avoid environmental contamination. See Section 10 for
incompatible materials before handling or use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Persons with a
history of skin sensitization problems should not be employed in any process in which
this product is used. Avoid exposure - obtain special instructions before use. Do not
handle until all safety precautions have been read and understood. Do not get in eyes
or on skin or clothing. Do not ingest. Use only with adequate ventilation. Wear
appropriate respirator when ventilation is inadequate. Keep in the original container or
an approved alternative made from a compatible material, kept tightly closed when not
in use. Empty containers retain product residue and can be hazardous. Do not reuse
container.
:
Precautions for safe handling
Crystalline Silica, respirable powder
14808-60-7
OSHA PEL Z3 (United States, 6/2016).
TWA: 250 mppcf / (%SiO2+5) 8 hours. Form:
Respirable
TWA: 10 mg/m³ / (%SiO2+2) 8 hours. Form:
Respirable
OSHA PEL (United States, 5/2018).
TWA: 50 µg/m³ 8 hours. Form: Respirable
dust
ACGIH TLV (United States, 3/2019).
TWA: 0.025 mg/m³ 8 hours. Form:
Respirable fraction
NIOSH REL (United States, 10/2016).
TWA: 0.05 mg/m³ 10 hours. Form: respirable
dust
Portland Cement
65997-15-1
ACGIH TLV (United States, 3/2019).
TWA: 1 mg/m³ 8 hours. Form: Respirable
fraction
NIOSH REL (United States, 10/2016).
TWA: 5 mg/m³ 10 hours. Form: Respirable
fraction
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Control parameters
Occupational exposure limits (OSHA United States)
CAS #
Date of issue/Date of revision
:
12/10/2019
Date of previous issue
:
10/19/2018
Version
:
7
5/13
60.100709
H&C® CONCRETEREADY™ Single-Component Quick Patch and Repair
Clear
SHW-85-NA-GHS-US