SDS

Section 2. Hazards identification
Precautionary statements
Prevention
:
Obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Wear protective gloves. Wear eye or face protection.
Wear protective clothing. Use only outdoors or in a well-ventilated area. Do not breathe
dust. Do not eat, drink or smoke when using this product. Wash hands thoroughly after
handling. Contaminated work clothing must not be allowed out of the workplace.
Response
:
Get medical attention if you feel unwell. IF exposed or concerned: Get medical
attention. IF INHALED: Remove person to fresh air and keep comfortable for breathing.
Call a POISON CENTER or physician if you feel unwell. IF ON SKIN: Wash with plenty
of soap and water. Wash contaminated clothing before reuse. If skin irritation or rash
occurs: Get medical attention. IF IN EYES: Rinse cautiously with water for several
minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
Immediately call a POISON CENTER or physician.
Storage
:
Store locked up.
Disposal
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
General
:
Read label before use. Keep out of reach of children. If medical advice is needed,
have product container or label at hand.
Hazards not otherwise
classified
:
None known.
Causes serious eye damage.
Causes skin irritation.
May cause an allergic skin reaction.
May cause cancer.
May cause respiratory irritation.
Causes damage to organs through prolonged or repeated exposure.
:
Hazard statements
Please refer to the SDS for additional information. Keep out of reach of children. Do not
transfer contents to other containers for storage.
Supplemental label
elements
WARNING: This product contains a chemical known to the State of California to cause
cancer. Adequate ventilation required when sanding or abrading the dried film. If
Adequate ventilation cannot be provided wear an approved particulate respirator
(NIOSH approved). Follow respirator manufacturer's directions for respirator use.
DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Abrading or sanding of
the dry film may release Crystalline Silica which has been shown to cause lung damage
and cancer under long term exposure.
:
Section 3. Composition/information on ingredients
Crystalline Silica, respirable powder
≥50 - ≤75
14808-60-7
Portland Cement
≥25 - ≤50
65997-15-1
Calcium Oxide
≤3
1305-78-8
Ingredient name
CAS number
% by weight
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health and hence require reporting in this section.
Other means of
identification
:
Not available.
Substance/mixture
CAS number/other identifiers
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
Date of issue/Date of revision
:
12/10/2019
Date of previous issue
:
10/19/2018
Version
:
7
2/13
60.100709
H&C® CONCRETEREADY™ Single-Component Quick Patch and Repair
Clear
SHW-85-NA-GHS-US