Technical Specifications

H&C Products Group Technical Service 1.800.867.8246 Page 1 of 3
101 W.Prospect Avenue www.hcconcrete.com
Rev.10/17
Cleveland, Ohio 44115 PDS ID: 111.64
PRODUCT DESCRIPTION
H&C® INFUSION® Water-Based Semi-Transparent Decorative
Stain is easy to apply semi-transparent decorative concrete
stain for interior and exterior use. A user-friendly exciting
alternative to reactive acid stains achieving a unique look for
every project.
*
H&C INFUSION Water-Based Semi-Transparent
Decorative is formerly known as H&C® Semi Transparent
Decorative Stains
FEATURES & BENEFITS
• Water-based formulation contains no acids or harmful
chemicals.
• Can be diluted or mixed to create infinite custom colors.
• No need for rinsing, mopping, or neutralizing after applying,
as with acid-based stains.
• Easy soap-and-water cleanup.
• Produces vibrant coloring effects when enhanced by
solvent- or water-based sealers and floor finishes.
RECOMMENDED USES
H&C INFUSION Water-Based Semi-Transparent Decorative
Stain is formulated for use on both interior and exterior bare
concrete surfaces including driveways, sidewalks, pool decks,
patios, and commercial and residential floors.
COVERAGE RATE
150-300 sq ft/gal
(Coverage will vary depending on the porosity and texture of the substrate.)
JOBSITE TEST SECTION
Due to the wide variety of substrates, preparation methods,
application methods and environments, it is important to
create a test sample.The final color may vary depending on
the concrete texture, age, type of sealer and other variables.
Always apply sealer to test sample.
LIMITATIONS
Apply in ambient and surface temperatures above 50° F and
below 90° F. Broomed or poorly finished surfaces may not
accept color due to excessive porosity. Use on fiber-reinforced
concrete may result in surface fibers standing up after sealing.
Tes
ting on fiber-reinforced surfaces
SURFACE PREPARATION
Concrete surfaces should be able to absorb water. To
test absorption, spray various sections of the surface to
be stained with water. If the water does not absorb
within 10 seconds, then acid etch the surface using
H&C® CONCRETEREADY® Etching Solution, following
label instructions. After proper etching, the surface
should feel like 120-grit sandpaper. If not, then etch
again.
New Concrete: Allow new concrete to cure at least 28 days
before applying. All surfaces must be clean, dry and free of
curing compounds, sealers, membrane-forming products and
bond breakers. Prior to staining the water test as specified
under surface preparation, above. On interior installations,
protection from hydrostatic pressure and moisture should be
part of the initial concrete design and slab installation
criteria.
Existing Concrete: Remove all surface contaminants such as
grease, glue, oil, laitance, efflorescence and loose mortar. For
optimum surface cleaning, use an orbital cleaning machine,
black scrubbing pad and H&C CONCRETEREADY Cleaner
Degreaser. When staining very aged and pitted or porous
concrete, apply one coat of H&C® ULTRAPAVER® Water-
Based Natural Paver Sealer. This will prevent the stain from
penetrating too deeply into the concrete and will aid color
distribution. Allow to dry 1 hour before applying H&C®
INFUSION® Water-Based Semi-Transparent Decorative Stain.
Previously Painted Concrete: To ensure proper pentertation
and color acceptance of H&C Infusion Water-Based Semi-
Transparent Stain, all paint, coatings and sealers must be
removed before stain installation. For best performance,
mechanically grind the surface. Vacuum or sweep away
grinding dust before stain application.*
*WARNING: Removal of old paint by sanding, scraping or other means may
generate dust or fumes that contain lead. To avoid exposure to lead dust,
wear proper protective equipment, such as a properly fitted respirator (NIOSH
approved) and follow proper containment and cleanup procedures. For more
information, call the National Lead Information Center at 1-800-424-LEAD (in
U.S.) or contact your local health authority.
TOOLS REQUIRED
• Plastic sheeting to cover walls and foilage
• Plastic water sprinkling can
• Pump-up sprayer
• Mops, sponges, rags and other faux-finishing tools (optional)
• Water hose for dilution and clean up
H&C® INFUSION ®
WATER-BASED SEMI-TRANSPARENT
DECORATIVE STAIN
•
Interior & exterior use
• Available in 16 ready-to-use colors
• Can be layered to create faux-finishing effects
 Respiratory Protection
 Gloves
 Eye Protection