Instructions

List of Parts

A X Brace W Pull Knob

B Keyboard Support Bars (White Dot & Green Dot)

C Base Support Bars (Pink Dot & Purple Dot)

D Hex Head Screws (x4)

E Allen Wrench

• Choose a large, ﬂat and non-slip area on which to unpack

and assemble your new stand. A carpeted surface works great!

• Start by laying out all the parts from the box and please

notice the 4 sets of colored dots that are placed on each

individual Part A through C.

• First pick up Part A and make sure that the pull knob is

oriented on your right side. Pull the knob and allow the X

Brace to open 2 clicks. Stand up the now X Shaped brace

on its 2 lower points and lean it against an appropriate

surface for a moment. It should look like a standing X.

• Holding Part A in one hand pick up Part B with the White

dot and place it over the shaft of Part A, matching up the

dots as in Figure 1. Apply pressure to Part B till it completely

settles onto the shaft of Part A. Tighten with 1 Hex Head

Screw (Part D) using the included Allen Wrench (Part E).

• Then pick up Part B with the Green dots, again placing it

over the remaining shaft of Part A also featuring green

dots. Apply pressure to Part B till it completely settles

onto the shaft of Part B. Tighten with 1 Hex Head

Screw(Part D) using the included Allen Wrench (Part E).

• Next pick up the stand as it is and ﬂip it upside down so

that the Support Bars you just attached are now on the ﬂoor.

• Now pick up Part C with the Pink dots and place it over the

shaft of Part A, matching up the dots as in Figure 1. Apply

pressure to Part C till it completely settles onto the shaft

of Part A. Tighten with 1 Hex Head Screw(Part D) using the

included Allen Wrench (Part E).

• Finally, pick up Part C with the Purple dots and place it

over the shaft of Part A, matching up the dots as in Figure

1. Apply pressure to Part C till it completely settles onto

the shaft of Part A. Tighten with 1 Hex Head Screw(Part D)

using the included Allen Wrench (Part E).

Your stand is now assembled and ready for use!

Pair up the colored dots

Then line them up as shown

Keyboard Stand Assembly Instructions