Datasheet

ACCESSORY
CHARGER
12 V
PN. 072411
The 4.5 W, solar charge holding kit is designed to maintain all 12 V lead-acid batteries. It
preserves the battery’s charge and service life during prolonged periods of inactivity (e.g.
long-term parking).
This kit can be connected to the battery in two dif ferent ways (by wire with interchangeable plugs, tot al length 2.8 m):
• directly to the battery terminals using the alligator clips
• from within the vehicle via the cigarette-lighter socket
The solar charge holding kit is very easy to set up:
1. Position the solar panel so that it faces the sun as much as possible. For example, on the vehicle’s front or rear
windows using the four suction cups provided.
2. Connect the alligator clamps or the 12 V DC socket to the solar panel and then to the battery or cigarette-lighter
socket.
3. The charge holding will start as soon as the solar panel receives enough solar energy.
SIMPLE-TO-USE, DUAL CONNECTOR TECHNOLOGY
34 cm
A RELIABLE AND ROBUST CHARGING ACCESSORY
• Reverse polarity protection
• Durable, water-resistant casing
+ -
www.gys-welding.com
Solar charge holding kit 4.5 W
cm
kg
Solar 12 V 4.5 W 35 x 23 0.8
4.5 W FOR A WIDE RANGE OF APPLICATIONS
The 4.5 W, solar kit maintains the charge of any 12 V
lead-acid battery for:
• Quad bikes and buggies
• Motorbikes and cars
• Caravans and mobile homes
• Boats and yachts
The device is not designed to remain permanently in use, it must be disconnected
before the engine is started or before energy is drawn from the battery.
Clips
SUPPLIED WITH
Socket
cigarette lighter
Four suction
cups
14/03/2022
MADE IN CHINA
-- IEC 61215
photovoltaic cells
CLEAN ENERGY ANY TIME AND ANYWHERE
• Capable of maintaining a current in all
weathers, even in low-light or overcast
conditions.
• Clean energy with no risk of interruption:
 cost eective
eco-friendly