Datasheet

MADE IN FRANCE
- EN 60974-1
EASYCUT K25
x 1
x 3
x 1
x 3
www.gys.fr
x 4
040182
x 10
040212
x 2
040175
x 10
040168
50/60 Hz

A

A
Max cut Clean cut
EN 60974-1 (40°C)
X (40°C)

cm

kg
IP
Acier Steel Alu Acier Steel Alu
230V 1~ 16 10
 25
8 6 6 4
15 A @ 60%
25 A @ 35%
41 x 36 x 20 15 IP21S
SINGLE-PHASE
PLASMA
CUTTER
10
 25 A
Ref. 068063
ACCESSORIES & CONSUMABLES
PERFORMANCE
Capacity Thickness
Separation
Fe 8 mm
Clean Cut
Fe 6 mm
The EASYCUT K25 plasma cutter, without high-frequency (HF) ignition,cuts easily through all
types of metal up to 8 mm thick. Its built-in compressor makes it ideal for a outdoor or remote
working where only an electricity supply is available.
Compass kit
040205
PLASMA 600 trolley
040298
TPT25 consumables kit
070721
Built-in air compressor
Quality cutting without distortion
No HF Start
In situations where the welder does not have access to
compressed air, the EASYCUT K25 is a perfect solution for
enabling outdoor work with its built-in compressor.
The use of plasma ensures high-quality cuts even on painted
structures:
up to 8 mm for steel, stainless steel and cast iron.
up to 6 mm for aluminium and copper.
Featuring the «Pilot Arc» system, the arc is initiated without
having to touch the workpiece. This non-HF ignition system
avoids all electromagnetic interference (from radios,
computers, telephones or from medical equipment, etc.).
The TPT25 torch (4 m) is equipped with a trigger safety device to
prevent accidental or unintentional activation.
Detachable torch and earth clamp allowing for easy
transport.
Built-in compressor (sound level: 60/70 dB).
Enhanced protection for working with power generators
and against permanent overvoltage up to 400 V.
Easy, quick and safe to use
P400
Duty cycle of 25 A @ 35%.
Comes with
2 m
10 mm
²
TPT 25
4 m
ref. 068063