Datasheet

MADE in P.R.C
- EN 60974-1
www.gys.fr
ømm
ømm
équipé d’origine /
original equipement /
originalausstatung /
equipamiento de fabrica
EN60974-1
(40°C)
50/60hz
min
▷max
200 300
IA
(60%)
X%
(I2 max)
cm/kg
Protected & compatible
POWER GENERATOR
(+/- 15%)
400V 3~ 10A
15
-200A
0.6 - 1.0
 
0.6
-
0.8
0.8 110A
150A
25%
47x77x79 / 50 5 kVA
CARMIG
EN 60974-1
Ideal for welding thin metal sheets, it has been designed to x cars at a minimum current of
15 A. The SMART interface facilitates settings, for considerable time saving.
Intuitive use
Professional level specication
The CARMIG simplies both wire speed and voltage settings.
Thanks to the SMART chart, nd the right settings based on metal
thickness and wire type.
Then, depending on the charts’ recommendations, simply select :
• Voltage (7 positions knob )
• Wire speeder by setting the potentiometer on the indicated colour
zone and adjust if needed.
Welding :
• Steel / stainless / CuSi3 / CuAl8 wire from Ø 0.6 to 1.0 mm.
• Alu wire (AlMg5) of Ø 0.8 mm.
400 V three phase power supply.
EURO Torch 150 A - 3 m.
Wire feeder motor 2 rollers of 40 W.
Takes 5 and 15kg wire reels (200 and 300 m).
Supports gas bottles up to 10 m³.
Compatible with an electrical generator (5 kVA).
Mobile thanks to its 4 wheels including 2 pivoting wheels.
Supplied with :
- 1 torch 150 A - 3 m
- 1 earth clamp 200 A - 3 m
(regulator not included)
Support
Gas bottle
4 m3 - 10 m3
Intuitive settings
thanks to coloured
and numbered code.
Ref. 032132
MIG-MAG
THREE PHASE
15▷200A