Datasheet

Ref. 026773
BOOSTER
BATTERYLESS
12 V
12 V
1.5 m
INCLUDED
deep-discharge batteries.
A POWERFUL BOOST

Designed around battery-free technology, it is equipped with 5 supercapacitors.
The supercapacitors guarantee 1,000,000 cycles (charge & discharge).
Energy of 1,600 A at start-up / 9,000 A at peak .
 Two start-up modes: automatic or forcing (SOS) for vehicles equipped with
Designed for vehicles equipped with a 12V battery, the GYSCAP 680E uses supercapacitor technology
(without battery) to provide instant starting power. It uses energy from a vehicle with engine running,
to automatically charge itself. It then uses this energy to start another vehicle. This device is fully
autonomous and does not need to be connected to the mains.
A PROVEN TECHNOLOGY
 Thousands of starts without stopping.
 Still operational even after years of storage.
EASY AND CONVENIENT
 Three charging modes:
• Connecting the clamps to a running vehicle
.
+
By leaving the GYSCAP plugged in for a few seconds after a vehicle is started, it automatically
recharges on the running engine.
• Plugging the cigarette lighter cord into any vehicle
.
+
This charge is very practical and avoids the need to access the battery terminals of the recovery vehicle.
In addition, the vehicle can be stationary, with power being taken from the cigarette lighter.
• Connecting to the mains via the supply mode of a Gysflash 4 A (029422 +
Acc.
Gysflash. 029439 - not supplied)

Insensitive to cold and heat (-40°C/+60°C) during storage, charging and use.
It guarantees a successful start, regardless of the weather conditions.
It can be used in all weathers and is not affected by rain or snow.
No maintenance required.
OPTIMAL SAFETY & INTUITIVE INTERFACE
Equipped with the SMART STARTER MANAGEMENT SYSTEM, it is protected against
reversed polarity/short-circuited clamps/deep discharge.
This system guarantees the safety of the on-board electronics, the battery of the
vehicle, the booster and the user.
 Incorporates a digital display capable of continuously and accurately providing the
voltage of the vehicle’s battery and alternator clamps. The state of charge of the
capacitors is indicated by the LED bar graph.
IDEAL FOR SITE USE
Reinforced plastic case.
100% copper cables, 25 mm² cross section and 170 cm length..
Fully insulated curved brass clamps.
Light weight of 8.2 kg
VUE CLAVIER
START
Farad
1V/C
Cranking
CC
PEAK
BATTERY
INPUT CHARGE

cm

kg
OPTION
5 x 3 000 F (3 V)
12 V
PETROL
& DIESEL
1 600 A 2 700 A 9 000 A 12 V ≈ 1 min
10 - 30 V
(150 W max)
30 min
(max)
4 A
1 h
(max)
35 x 44 x 19 8,2
MADE IN FRANCE
GYSCAP 680E
IEC-60335-2-29
www.gys.f r