Owner`s manual

A A
Troubleshooting
Common Problems and Solutions
Problem Cause Solution
Cursor Control Issues
The Display screen does not
match or show the updates to
the Windows Media Player or
iTunes audio library.
The Menu Navigation buttons
are non-responsive while the
Display screen is active.
The cursor does not move
when the “Motion by
Gyration” button is pressed.
The Gyration Music Service
Application did not update
correctly.
The Display screens needs to
be manually refreshed.
The Display screens needs to
be manually refreshed.
The Gyration Music Service
Application has lost contact
with the remote control.
The remote control is out of
range with the computer.
(Display shows: out of range)
The remote control and
computer are not connected.
The batteries are low.
Restart Application, by clicking
the Gyration Music Service
(green) icon on the Windows
Taskbar, and clicking “Restart.”
Press the button to return
to the Main Menu.
Use the menu navigation
buttons to move up or down
from the current level in the
Display screen.
Refresh the Display screen by
pressing the button for
three seconds to shut off the
Display screen, then pressing
the button again to turn
the Display screen back on.
Place the remote control closer
to the computer.
Connect the RCU with your
computer.
Replace the batteries.
Adjusting the Contrast on the Display
To adjust the contrast on the Display, perform the following steps:
1. With the Display screen active, press and hold the button located beneath the Display screen.
2. Continue to hold the button after the Display screen turns off for 5 more seconds.
3. The Display Contrast adjustment screen will appear.
4. Use the menu navigation up and down arrows to adjust to the desired appearance.
5. Press any button to exit.
6. If no button is pressed, the display will time out in about 5 seconds.
Note: The contrast settings range from 0 (lightest) to 21 (darkest). Low levels of the
contrast setting may cause the unit to have no visible display.
Note: The contrast value is stored, even when removing the batteries.
Reinstalling the R4000 Installation Software
To reinstall the R4000 Installation Software service application, perform the
following steps:
1. With Windows
®
running on your computer, insert the CD into your CD/DVD-ROM drive.
2. If the CD window does not open automatically, double-click the My Computer icon on
your desktop, and then double-click the CD/DVD-ROM drive containing the CD.
3. Locate the install package provided on the CD for your RCU.
4. Follow the instructions provided by the CD to extract and install the application.
Troubleshooting
27 28