Instructions / Assembly

ManualsBrandsGymojoy ManualsOutdoor Lounge FurnitureCarolina Gray Wicker Outdoor Loveseat with CushionGuard Gray Cushions

PRE-ASSEMBLY PREPARATION:

--- Please read through the instructions before beginning assembly.

--- Clear out the space for assembly and lay out all of the parts based on the Parts List, extra room will allow you to easily determine if all the pieces are present.

--- Keep small parts and pieces away from children until fully assembled.

Step 1: Guide build-in nuts on back panel (B) into the holes on left arm (A1) and

right arm (A2). Attach left arm (A1) and right arm (A2) to back panel (B) with 4pcs

bolts (E) and 4pcs washers (D).

* Do not fully tighten bolts until the entire frame is assembled.

* Notice the position of left arm (A1) and right arm (A2), swapped arms would cause

asembly failure. (Side wall of arm should be towards inside)

Step 2: Place seat panel (C) between arms and back panel, attach it to arms (A1 and A2)

with 4pcs bolts (F) and 4pcs washers (D), and then attached to back panel with 3pcs bolts (F)

and 3pcs washers (D).

Verify the alignment and adjust, now fully tighten all the bolts using hex wrench (G). Put seat

cushion and back pillows on.

* Due to design and weaving handicraft limitation, it may has around 1/2 in. gap between arms

and back panel after assembly. It is normal and will not affect outlooking and daily usage.